User manual DIGITECH RP55

[. . . ] MODELING GUITAR PROCESSOR Owner's Manual Warning For your protection, please read the following: Water and Moisture: Appliances should not be used near water (e. g. near a bathtub, washbowl, kitchen sink, laundry tub, in a wet basement, or near a swimming pool, etc. ) Care should be taken so that objects do not fall and liquids are not spilled into the enclosure through openings. Power Sources: The appliance should be connected to a power supply only of the type described in the operating instruction or as marked on the appliance. Grounding or Polarization: Precautions should be taken so that the grounding or polarization means of an appliance is not defeated. [. . . ] Disconnecting your instrument from the Input of the RP55 disconnects the battery power. Turn your amplifier(s) on and adjust the volume(s) to a normal playing level. Alternate tunings are A = Ab (displayed as Ab), A = G (displayed as G), and A = Gb (displayed as Gb). The display window briefly flashes the selected tuning preference. Exit 9 tuner mode by pressing either Footswitch. The tuning reference is retained when the unit is turned off. Bypass The RP55 presets can be bypassed for a clean, unprocessed guitar tone. To bypass the RP55, press both footswitches simultaneously. The display reads By indicating the preset is bypassed. Press either footswitch to exit Bypass and return the last selected preset. Editing/Creating Presets Creating your own signature sound with the RP55 is easy and intuitive. The RP55 lets you create your own presets, or fine tune existing Presets to suit your needs. When creating or editing a sound, you must start with a User or Factory Preset. It is not possible to start with an empty preset. You can save your preset to any User Preset location while storing the preset (see Storing a Preset pg 12). Press the FOOTSWITChES to select a preset 2. Press the EDIT buttons in conjunction with the Effect LEDs to choose the effect you want to edit. Press the VALuE Buttons to change the parameter values. 10 The Effect LEDs When editing a preset, the Effect LEDs are used to indicate which effect is selected for editing. The Edit buttons move you through the Effect modules. The LEDs light indicating which effect group is selected. Each effect has multiple settings to select from. The Value buttons are used to change the value for the selected effect. As a button is pressed, the value or status is shown in the display. The EDIT/EFFECT buttons select which effect to edit. The VALUE/MASTER VOLUME buttons edit the selected effect. When the stored value of an effect is changed, the lower right decimal point in the display lights indicating you need to store the changes. Changing presets, or turning the power off before storing any changes will erase any changes made and revert to the stored values for the preset. 11 Storing/Copying a Preset Once the preset has been modified, you may store your settings to one of the 40 User Preset locations (Presets 1-40). [. . . ] Any passive mono volume or TS (tip/sleeve) expression pedal can be used as an expression pedal with the RP55. TRS expression pedals are not supported. Connect from the output of a supported volume or expression pedal to the Expression Pedal Input on the RP55. The expression pedal controls the RP55's Volume, Wah, or WhammyTM parameters. [. . . ]