User manual DIGITECH S100

[. . . ] Dual Engine Multi-Effects Processor User's Guide Please visit Digitech Studio on the World Wide Web at http://www. digitech. com CAUTION RISK OF ELECTRIC SHOCK DO NOT OPEN WARNING FOR YOUR PROTECTION, PLEASE READ THE FOLLOWING: WATER AND MOISTURE: Appliance should not be used near water (e. g. near a bathtub, washbowl, kitchen sink, laundry tub, in a wet basement, or near a swimming pool, etc). Care should be taken so that objects do not fall and liquids are not spilled into the enclosure through openings. POWER SOURCES: The appliance should be connected to a power supply only of the type described in the operating instructions or as marked on the appliance. [. . . ] 9-b) Engine A - This button selects the Engine A effect module. Once this button is pressed, use the <Program/Data> User Guide 5 Section -1 Introduction wheel to change the effect used in this module. S-100 9-c) Engine B - This button selects the Engine B effect module. Once this button has been pressed, use the <Program/Data> wheel to change the effect used in the module. 9-d) Parameter 1 / Predelay - This button selects parameter 1 for editing in conjunction with the <Program/Data> wheel. It is also the Predelay parameter of the Reverb effect. 9-e) Parameter 2 / Decay - This button selects parameter 2 for editing in conjunction with the <Program/Data> wheel. It is also the Decay parameter of the Reverb effect. 9-f) Parameter 3 / Damping - This button selects parameter 3 for editing in conjunction with the <Program/Data> wheel. It is also the Damping parameter of the Reverb effect. 9-g) Parameter 4 / Level - This selects parameter 4 (level) for editing in conjunction with the <Program/Data> wheel. 10) Bypass - This button is used to Bypass all of the digital effects in the S-100 and allow the original dry signal to pass through the S-100. 6 User Guide S-100 Section -1 Introduction The Rear Panel 1 2 3 4 5 6 7 8 INPUT LEVEL LEFT/MONO IN RIGHT IN LEFT/MONO OUT RIGHT OUT POWER SUPPLY FOOTSWITCH MIDI IN 1) Input Level- This knob controls the level of signal entering the S-100. For optimal performance, set this level so the Input level indicators (located on the front panel) occasionally light the red LEDs. 2) Left/Mono Input - This Input jack is used for the Left or Mono input. When only the Left input jack is used, the signal is sent to both Left and Right S-100 inputs. 3) Right Input - This is the Right Input jack for the S-100 that when used with Left input will preserve stereo imaging. 4) Left/Mono Output - This is the S-100's left audio output. This output must be used if a mono effect is desired. 5) Right Output - This is the S-100's right audio output. Use both left and right outputs to take advantage of stereo effects. 6) AC Line Input - This is the AC adapter receptacle. Use only the included PS 750 power supply. 7) Footswitch Jack - This jack is used for the insertion of the Digitech FS-300 footswitch that will control program changes and Bypass the digital effects of the S-100. [. . . ] Range is from 0 to 99 milliseconds. Delay Time This parameter controls the length of the Delay Time that is offered in the Karaoke. Delay Time settings are 1-5. Feedback This parameter controls the amount of delay repeats in the delay effect. Range is from 0 to 99% and repeat-hold (rh). Repeat This parameter controls the amount of delay repeats in the D-4 Karaoke effect. Range is from 1 to 10. Level This parameter allows you to set the overall level of the selected effect. [. . . ]