User manual DIGITECH TONE DRIVER

[. . . ] Harman Music Group 11. WARNING:To reduce the risk of fire or electric 8760 South Sandy Parkway shock, do not expose this apparatus to rain or Sandy, Utah 84070 USA moisture. Refer to labels on the unit, including bottom cover, for Fax: (801) 568-7583 other markings and pertinent information. Product name: Tone Driver Product option: all (requires Class II power adapter that conforms to the requirements of EN60065, EN60742, or equivalent. ) WARRANTY: We at DigiTech are proud of our products and back-up each one with the following warranty: 1. The warranty registration card must be mailed within ten days after purchase date to validate this warranty. DigiTech warrants this product, when used solely within the U. S. , to be free from defects in materials and workmanship under normal use and service. DigiTech liability under this warranty is limited to repairing or replacing defective materials that show evidence of defect, provided the product is returned to DigiTech WITH RETURN AUTHORIZATION, where all parts and labor will be covered up to a period of one year (this warranty is extended to a period of six years when the product has been properly registered by mail or through our website). [. . . ] Turn this knob clockwise to increase the output level, and counter-clockwise to decrease output level. 2. Tone Knob Controls the boost or cut of high frequencies. Turn this knob clockwise to increase the high frequency content, and counter-clockwise to decrease the high frequency content. AC Adapter Jack Connect a DigiTech PS200R power supply to this jack. Use the proper supply for your area's Mains line voltage. 1 234 5 11 10 9 6 7 8 4. Gain Knob Controls the amount of overdrive distortion. Turn this knob clockwise to increase the amount of distortion, and counter-clockwise to decrease the amount of distortion. Morph Knob Morphs the three different overdrive voicings. The minimum position is an edgy, mid boost overdrive. The 12 o'clock position is a smooth warm overdrive sound. The maximum position is a classic overdrive with extra gain for when you need it. Experiment with the knob's different positions to hear the wide variety of overdrive tones. Input Jack Connect your instrument to this jack. Connecting a guitar cable to this jack engages battery power even though the Indicator LED may not be lit. To prolong battery life, disconnect all cables from the pedal when not in use. 7. Pedal Release Pins These two pins are spring-loaded hinges that hold the pedal in place. Push these pins in to release the pedal from the chassis exposing the battery compartment. Out 1(Amp) Jack Connect this output to your guitar amplifier. [. . . ] Using the tip of a 1/4" guitar cable, push one of the release pins in on either side of the pedal, and remove the pedal from the pedal chassis. Remove the battery from the battery compartment and disconnect the battery cable. Connect a new battery to the battery cable and put it back in the battery compartment. Make sure the battery cable does not interfere with the spring or pedal switch arm. [. . . ]