User manual DIGITECH TSR24S QUICKSTART

[. . . ] By doing so you will ensure that your disposed product undergoes the necessary treatment, recovery and recycling and thus prevent potential negative effects on the environment and human health. Table of Contents Section One - Introduction Section Four - Other Functions Getting Acquainted . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1 Included Items . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1 About the TSR24S QUICKSTART . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1 Performance Mode . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ] Ranges from 0 (toe up) to 99 (toe down). WahMaximum-Knob3 adjusts the Wah Pedal Maximum. Ranges from 0 (toe up) to 99 (toe down). Wah Level - Knob 6 adjusts the Wah Level. Ranges from 0dB to +12dB. 13 Compressor A Compressor is used to increase sustain, tighten up guitars, and prevent the signal from clipping the input of other effects. It sets a maximum boundary for the strength of a signal. Comp Model - Knob 1 selects one of three Compressor models: DIGCMP (DigiTech® Compressor), CSCOMP (Based on a Boss® CS-2 Compressor/Sustainer), or DYnCOMP (Based on an MXR® Dynacomp). Press this knob to turn the selected Compressor model on and off. Knobs 2-6 have the following functions for the various Compressor models: Compressor Model digcmp cscomp dyncmp Knob 2 (Sustain) Sustain Sustain Sensitivity Knob3 (Tone) Tone --Knob 4 (Attack) Attack Attack -Knob5 Knob 6 (Compressor Level) Level Level Output ---- Distortion The TSR24S QUICKSTART models the tones of 18 popular distortion stompboxes, each of which can be tweaked and modified, just like the real thing. Distortion Model - Knob 1 selects one of the selected Distortion model on and off. scream - Based on an Ibanez® TS-9 808 - Based on an Ibanez TS-808 Tube Screamer Spark - Based on a Voodoo Lab Sparkle Drive oddriv - Based on a Guyatone® Overdrive OD-2 dod250 - Based on a DOD® 250 Overdrive/Preamp redlne - DigiTech Redline - Modified Overdrive rodent - Based on a Pro Co RATTM mxdist - Based on an MXR® Distortion + DSDist - Based on a Boss® DS-1TM Distortion 18 Distortion models. The display will show which channel is selected (Amp A or Amp B). EQ Model - Knob 1 selects between 4 different EQ modes (Mid Boost, Scoop, Bright, and Warm), each with different frequency centers for Mid and Treble. Pressing this knob turns the EQ on and off. Bass - Knob 2 adjusts the amount of low end level (Bass). Mid Frequency - Knob3 selects the frequency that the Mid parameter adjusts. MidRange-Knob 4 adjusts the amount of midrange level. Treble - Knob5 adjusts the amount of high end level (Treble). Presence - Knob 6 boosts or cuts the Presence level for the selected channel. Treble Frequency (X-EditTM only) - This parameter selects the frequency that the Treble parameter adjusts. Ranges from 500 Hz to 8000 Hz. 17 Noise Gate/Auto Swell A Noise Gate is designed to eliminate noise while you are not playing, or provide an auto volume swell effect. Gate Model - Knob 1 selects between the DigiTech® noise gate or the volume swell effect. [. . . ] This procedure erases all custom User presets, and recalibrates the Expression Pedal. ATTENTION: Performing this function will erase all user-programmed data. All suchdatawillbelostforever!Besureyouwanttoerasethememoryandstart fresh before continuing with this procedure. The procedure for performing a Factory Reset is as follows: 28 1. [. . . ]