User manual DIGITECH VX400

[. . . ] User's Guide IMPORTANT SAFETY INFORMATION LITHIUM BATTERY WARNING CAUTION! The symbols shown above are internationally accepted symbols that warn of potential hazards with electrical products. The lightning flash with arrow point in an equilateral triangle means that there are dangerous voltages present within the unit. The exclamation point in an equilateral triangle indicates that it is necessary for the user to refer to the owner's manual. These symbols warn that there are no user serviceable parts inside the unit. [. . . ] The recording can repeat just once, several times, or infinitely (which turns off the input to the Delay and allows you to play over the top of a passage in the Delay loop). Delay Type/Off - The Number 1 Knob turns the Delay on (On) and off (OF) and selects one of the 3 different types of Delay. Values include: DIGTAL (Digital Delay), ANALOG (Analog Delay), P PONG (Ping Pong Delay). Delay Time - The Number 2 Knob adjusts the amount of Delay time. Ranges from 10 MS through 2 Sec (10 ms through 1 sec in 10 ms increments and 1 sec through 2 sec in 100 ms increments). Feedback - The Number 3 Knob adjusts the number of times the delayed signal will repeat. Ranges from 1 to 99 and repeat hold (infinite repeat). Delay Level - The Number 4 Knob adjusts the volume of the delayed signal. Master Level - The Number 5 Knob controls the Vx400's Master Level. Reverb Reverb can give the listener a sense that the material is being performed in various acoustical environments. It can provide the tight acoustics of a small room, or the ambience of huge arena. Reverb Type/Off - The Number 1 Knob selects the Type of Reverb or acoustic environment and turns the Reverb off (OF) or on (oN). The Vx400 provides your choice of eight different 15 environments including: Creating Presets HALL = Hall PLATE = Plate ROOM = Wood Room CHAMBER = Chamber GARAGE = Parking Garage CHURCH = Church ARENA = Arena SPACE = Space Decay - The Number 2 Knob adjusts the length of time the Reverb is audible. Damping - The Number 3 Knob controls the amount of sound which is absorbed in the simulated environment. Reverb Level - The Number 4 Knob adjusts the volume of the Reverb. Master Level - The Number 5 Knob controls the Vx400's Master Level. Expression Pedal The Expression Pedal on the Vx400 can be assigned to control the Vx400's Volume, WhammyTM, or just about any other parameter in real time with your foot. When a parameter has been assigned to the Expression Pedal, a programmable minimum and maximum value can also be assigned. The procedure for assigning a parameter to the Expression Pedal is as follows: 1. Press the SELECT button until the light in the Expression row of the Matrix's LED begins flashing. Rotate the Number 1 Knob to select the Expression pedal 1, 2, or 3. Note: You can assign three parameters to the Expression pedal per preset. Rotate the Number 2 Knob to select the parameter the pedal will control. Rotate the Number 3 Knob to adjust the minimum value the pedal (toe up) reaches. [. . . ] The tone controls can still be accessed from the editing matrix or from X Edit. · Dry instrument can only be recorded on a separate track, not as part of a mix. To record the instrument in, go to the setup level of the matrix and select DRYINS in USB1-2 Source or USB3-4 Source. · Instrument with reverb or effects can be recorded as a mix with the microphone. [. . . ]