User manual DIGITECH WHAMMY

[. . . ] Grounding or Polarization: Precautions should be taken so that the grounding or polarization means of an appliance is not defeated. Power Cord Protection: Power supply cords should be routed so that they are not likely to be walked on or pinched by items placed upon or against them, paying particular attention to cords at plugs, convenience receptacles, and the point where they exit from the appliance. Servicing: To reduce the risk of fire or electrical shock, the user should not attempt to service the appliance beyond that described in the operating instructions. All other servicing should be referred to qualified service personnel. [. . . ] Everything should e included and in perfect working order. Before you get started, please make sure that the ollowing items have been included: WhammyTM Pedal PS750 or PS913 Power Supply User's Guide Warranty Card anything is missing, contact the factory at once. Please take a moment to complete your warranty card. It is your safeguard should a problem arise with your WhammyTM. User's Guide Guided Tour Detailed Descriptions 12 5 6 3 4 7 8 9 . Preset Knob - This knob is used to select the WhammyTM (bend), Harmony intervals, or Detune range controlled by the treadle. Bypass LED - This LED lights to indicate the effect is on. User's Guide Page3 . Treadle - This Pedal is used to bend the input note, bend between harmony intervals, or mix detuning with your input signal. Bypass Switch - This switch turns the effect on and off. Input - Connect your instrument to this jack. MIDI In - Connect any external MIDI device to this jack for the purpose of controlling the WhammyTM remotely. Power - Connect the provided power supply to this jack. Do not use any power supply other than the supplied PS750 or PS913. Dry Output - This jack contains your dry guitar signal only. . Wet Added Output - This jack contains a mix of your dry guitar signal, and the pitch shifted signal produced by the WhammyTM. User's Guide Making Connections he WhammyTM pedal is extremely easy to set up and use. Simply follow these steps and you be Whammin. Connect your instrument to the WhammyTM input. Connect from the "wet added" output to a your favorite distortion pedal or to your amplifier. Connect from the WhammyTM Dry Out to a guitar tuner if desired. Connect from the MIDI Out of a MIDI controller to the MIDI In on the WhammyTM if desired. Connect the power supply between an AC outlet and the power jack on the WhammyTM. . Turn on you amp and adjust the volume to a desired level. [. . . ] As the pedal is rocked forward, the detuned signal is mixed with the dry gnal. The Detune Presets include: Detune Presets Shallow - The copied signal is shifted slightly out of tune from the original pitch. Deep - The copied signal is shifted substantially out of tune from the input signal. User's Guide MIDI Functions A new feature found in this incarnation of the WhammyTM is a MIDI input. MIDI messages can elect a WhammyTM Preset, engaged or disengaged the effect, and control the pedal position. MIDI Channel he WhammyTM MIDI channel is used for receiving incoming MIDI data only. The WhammyTM can eceive MIDI messages on any, or all MIDI channels. The following steps outline the procedure for ccessing or changing the MIDI channel: . [. . . ]