User manual DIMPLEX DEE 2103

[. . . ] The tap and outlet fittings must be approved for operation with closed (pressurized) continuous-flow heater systems. The continuous-flow heater can be operated with cold or pre-warmed water (for example, from a solar energy unit water supply). Observe the technical data and the special accessories for this purpose. Only connect the continuous-flow heater to a cold water line. [. . . ] Status display on the appliance Appliance status Off Ready Appliance is heating Desired water temperature is not reached (water flow too high for appliance rating). The filter upstream from the check valve in the cold water supply inlet is clogged. DEE 1803 Rated output Rated voltage Fuse protection Minimum conductor cross-section Warm water flow at rated output with temperature increase from 12 °C to 38 °C 12 °C to 60 °C Start-up flow Start-up flow pressure * Application area in water specific electric resistance at 15 °C Rated pressure Maximum permissible supply temperature Maximum mains impedance at connection point * The pressure loss on the mixer must also be added. Pipe kit DLE 02RBS: for use of the continuous-flow heater as an under sink appliance Priority switch (load shedding relay): for operation with a priority circuit Mounting kit DLE 02AP: for surface mount installation Please read the operating instructions carefully before you use the appliance!With the use of a thermostat battery, the following settings are recommended for high temperatures or large quantities of water, for example: Dish washing Cleaning Bath tub This appliance is intended for domestic use or for household-based non-commercial applications. Usage in employees catering facilities for shops, offices, agricultural and other commercial operations, as well as usage by guests of guest houses, small hotels and similar residential establishments. Switch off the mains voltage supply immediately if a fault occurs. We do not accept liability for damage resulting from failure to heed these instructions. The continuous-flow heater may only be connected and put into operation by a qualified professional. Persons (including children) with diminished bodily, sensory or mental perception, or those who lack knowledge or experience should not operate the appliance, unless they are monitored or have received instruction concerning use of the appliance by persons responsible for their safety. Please monitor children to ensure that they do not play with the appliance. the mixer and the warm water pipe may be hot . Please switch off all fuses immediately if a malfunction occurs. Immediately shut off the cold water supply to the appliance should it leak. The continuous-flow heater switches on and heats the water when the hot-water tap is turned on. It switches off again when the tap is turned off. If a higher temperature for a completely opened warm water tap is not achieved, more water flows than the flow-through heater can warm as a result its performance capabilities. In this case, the warm water tap must be closed somewhat. The electronically regulated flow-through heater warms the water while it flows through the unit. Switch off the appliance (unscrew the fuse in the house electrical installation). Turn on the hot-water tap until the air is purged from the pipe. Mixing with cold water at the armature for water that is too hot consumes unnecessarily water and energy. [. . . ] Should the appliance not start because of a reduced flow-rate, remove the perlator, shower head or similar before start and repeat the process. If the fault could not be eliminated, please call customer service. Of your appliance when calling in a customer service engineer. This appliance is labelled in accordance with European Directive 2002/96/EG concerning used electrical and electronic appliances (waste electrical and electronic equipment ­ WEEE). [. . . ]