User manual DIRECTV SIR-S60W

[. . . ] DIRECTV Multi-Satellite Receiver SIR-S60W Owner's Manual Warning!Important Safety Instructions CAUTION RISK OF ELECTRIC SHOCK DO NOT OPEN CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT REMOVE COVER (OR BACK). REFER SERVICING TO QUALIFIED SERVICE PERSONNEL. This symbol indicates high voltage is present inside. It is dangerous to make any kind of contact with any inside part of this product. This symbol alerts you that important literature concerning operation and maintenance has been included with this product. Note to CATV system installer: This reminder is provided to call CATV system installer's attention to Article 820-40 of the National Electrical Code that provides guidelines for proper grounding and, in particular, specifies that the cable ground shall be connected to the grounding system of the building as close to the point of cable entry as practical. [. . . ] You can catch important information using the Freeze button, such as toll free numbers from TV advertisements. While in the GUIDE, press this button to sort the program listings by subcategory. INFO Press this button to display the Channel Banner and information about the current program. This button works when you are watching DIRECTV programming or in the guide. EXIT Press this button to exit any menu and return to the program you were watching. Number buttons (0-9) Press the number buttons to tune directly to a particular channel or to enter numerical values in the menu system. MENU Press this button to access the Main Menu. QUICK Press this button to display the QUICK GUIDE. (PLAY) Press this button to PLAY a VCR tape or DVD disc. GUIDE Press this button to display the GUIDE. (STOP) Press this button to STOP a VCR tape or DVD disc. Up/Down/Left/Right Arrows Use these buttons to scroll through any on-screen menu. (RECORD) Press this button to RECORD to a VCR tape. OK/ Press this button to select highlighted items in the menu system. After entering a channel number using the 0-9 buttons, you can press the OK button to tune to that channel. This button also accesses DIRECTV INTERACTIVETM program enhancements when you see the icon appear on your TV screen. (PAUSE) Press this button to PAUSE a VCR tape or DVD disc. Press PLAY or PAUSE again to resume. (REW) Press this button to Rewind a VCR tape or DVD disc. WHO (RED button) Press this button to change the current user profile. (FF) Press this button to Fast Forward a VCR tape or DVD disc. AUDIO (GREEN button) While watching TV, press this button to select an alternate audio track. While in the GUIDE, press this button to view future program listings in the guide. ?(HELP) Press this button to display help messages about the screen or menu currently on the TV. 18 Using Your Remote Control Pr ogramming Your Remote Contr ol Manual Mode You can program your remote control to operate other components in your home entertainment system such as your TV, VCR, or DVD player. You can enter individual device codes using the manual mode. 1 2 3 4 5 Turn on the device you want to control. Press the device button (example: The device button should light up. TV ) and the SET button simultaneously. Enter the three-digit code of your device (see Appendix). If the entered code is correct, the device will turn off. The button should blink twice and then turn off. Scaning Mode Use the scanning mode to scan through the list of codes for a particular device. This could take some time because there might be many codes for the selected device. 1 2 3 4 5 6 Turn on the device you want to control. Press the device button and the should light up. SET button simultaneously. The device button Repeatedly press the CH+ or the CH- button to scan through the device codes. The device button will blink each time you press the CH+ or CH- button. When the device turns off, stop pressing the CH+ CH- buttons. Press the device button again. The button should blink twice and then turn off. To operate a device using your remote control, first press the corresponding device button ( TV , SAT , VCR , DVD ). The TV , VCR , and DVD buttons need to be programmed to work the particular components of your entertainment system. 19 Viewing DIRECTV Programming Changing Channels There are several ways to change the channel you are watching: 1 2 3 Press the Press the CH+ CH- button on the remote control to tune to a higher channel number. button to tune to a lower channel number. Enter a channel number directly with the 0 - 9 number buttons. After entering a number, press the button or wait a few seconds for the system to tune to the new channel. Use the Quick Guide (see page 22) or the Full-Screen Guide (see page 25) to change channels. Channel Banner The Channel Banner displays at the top of the screen for a few seconds after changing the channel. Press the EXIT button to remove the Channel Banner from the screen, or wait a few seconds for it to automatically disappear. [. . . ] (1. 3kg) Audio Decoding MPEG-1 layerII, ISO/IEC11172-3 Sampling frequency : 48 kHz Satellite Antenna Interface RF Input : F-type connector RG-6 cable Package Contents SIR-S60W Multi-Satellite Receiver IR universal remote control Two AAA batteries Access Card Owner's Manual RF Cable A/V (RCA type) Cable Telephone code (RJ-11 Interface) Input/Output Interface Satellite input Video output : RCA type Audio output : Audio L/R RF Channel 3/4 : TV/VCR (input/output) RJ-11 (Modem Interface) Smart card reader Electrical Main power supply : 90 ~ 250V, 50, 60 Hz Power consumption : max. 30W Environment Temperature Operating : 32 to 113°F(0 to 45°C) Storage : 14 to 158°F(-10 to 70°C) 50 Warranty SAMSUNG DIGITAL SATELLITE RECEIVER LIMITED WARRANTY TO ORIGINAL PURCHASER This SAMSUNG brand product, as supplied and distributed by Samsung Electronics America, Inc. (SAMSUNG) and delivered new, in the original carton to the original consumer purchaser, is warranted by SAMSUNG against manufacturing defects in materials and workmanship for a limited warranty period of: One (1) Year Parts and Labor* (*90 Days Parts and Labor for Commercial Use) This limited warranty begins on the original date of purchase, and is valid only on products purchased and used in the United States. To receive warranty service, the purchaser must contact SAMSUNG for problem determination and service procedures. [. . . ]