User manual DIRT DEVIL DDC1800P

[. . . ] This locked position is convenient for storage and for lifting of the Powerhead. To release wand from the vertical locked position, gently place foot on Powerhead, grasp wand and pull back firmly. (B) OPERATING PROCEDURES Your Turbine Powerhead has no on/off switch. Whenever it is attached to an operating vacuum system, it will be running. No adjustments to the tool are necessary for different types of carpeting. [. . . ] Turn off vacuum system and disconnect powerhead. Remove belt cover as described in procedure C. Remove the 3 screws securing the metal baseplate. Lift front of baseplate up from bumper, then pull baseplate free of unit. Stubborn debris may now be easily removed from the brush area. PLEASE NOTE: Correct brush and belt orientation; they must be re-installed correctly for proper function. Slide the belt up off the end of the drive shaft. Partially remove the bumper by lifting it free from the front and sides of the housing. Lift the lower belt shroud, brush, belt and support assembly out of the housing, and remove the belt from the brush. Leave upper belt shroud installed in the housing, unless stubborn debris remains lodged below it. Pull the right brush support (marked ‘R’) off the assembly and remove the brush from the shaft. 2) (C) CLEANING BRUSH Turn off vacuum system and disconnect Powerhead Brush. Threads, string, carpet fiber, fuzz, etc. These should be removed by unwinding them by hand or carefully cutting with scissors. (Note: Brown base plate should be removed to clean properly). Keeping the cleaning brush clean will maintain efficiency of the Powerhead Brush. (D) CLEANING INTAKE NOZZLE If turbine or intake nozzle become obstructed: 1. Turn off vacuum system and disconnect Powerhead. Remove brown base plate by first sliding the base plate latch toward the back of the brush. Next, pull the rear of the plate away from the housing and slide forward to disengage front locking tabs. Remove debris from intake port and/or turbine. Reassemble by inserting the tabs on the front of the base plate into the slots in the base housing, then secure the back of the brown base plate with the latch. Page 5 (E) BELT REPLACEMENT Remove brown base plate and belt cover (right side of Powerhead) by removing screw. Next, remove belt from pulley (may help to turn cleaning brush backwards slightly. ) (See Fig. [. . . ] SPECIFICALLY DISCLAIMS RESPONSIBILITY FOR CONSEQUENTIAL AND INCIDENTAL DAMAGES, AND LIMITS THE IMPLIED WARRANTY OF MERCHANTABILITY TO THE PERIOD OF EFFECTIVENESS OF THIS EXPRESS WARRANTY. H-P PRODUCTS, INC. , Louisville, Ohio 44641 U. S. A. (216) 875-5556 TROUBLE SHOOTING TURBINE POWERHEADS CAUTION Moving parts – disconnect from vacuum system before servicing unit PROBLEMS 1. BRUSH HARD TO PUSH POWERHEAD INSTRUCTION MANUAL 1. [. . . ]