User manual DIRT DEVIL EG1200

[. . . ] Turn off all controls before unplugging. Do not use to pick up flammable or combustible liquids such as gasoline or use in areas where they may be present. Always turn off this appliance before connecting or disconnecting either hose or motorized nozzle. Do not use if damaged, cut or punctured. [. . . ] The headlight will operate when the EG1200 is turned on. To lower wands, hold the EG1200 down Fig. The powerhead has a pile height adjuster for various carpet heights. C) Use the low setting for short napped carpets and the high setting for plush carpets. CAUTION: Do NOT leave the EG1200 running in one spot in the upright position for any length of time. Damage to carpet may occur. Attachments Using attachments on the hose handle: Fig. Press lock button, then pull to remove handle from wand. D) NOTE: if the EG1200 is attached, turn the powerhead off before removing handle from wands. Slide attachments firmly on hose handle as needed. In some cases, the button may need to be depressed to allow the attachment to slide up higher where it can seal on the metal tube. To remove the wands from the EG1200, lock wands in straight-up position. Remove EG1200 plug and cord from holders. Disconnect cord and steady the EG1200 with foot and turn wands until lock button disappears, then pull the wands out. In some cases, the button may need to be depressed to allow the attachment to slide up higher where it can seal on the metal tube. Fig. G Performance Features Edge Cleaner Active brush edge cleaners are on both sides of the EG1200. Guide either side of the EG1200 along baseboards or next to furniture to help remove dirt trapped at carpet edges. Overload Protector The EG1200 has built-in protection against motor and belt damage should the brush jam. If the brush slows down or stops, the overload protector button pops up and shuts off the EG1200. The power unit will continue to run. Suction Control The suction control allows you to change the vacuum suction for different fabric and carpet weights. Opening the control decreases suction for draperies and lightweight rugs, while closing the control increases suction for upholsteries and carpets. Maintenance and Care WARNING!!!Disconnect electrical supply before servicing or cleaning the unit. Failure to do so could result in electrical shock or personal injury from cleaner suddenly starting. Always follow all safety precautions specified when caring for your EG1200. Changing the Light Bulb 1. Remove the light cover by pressing in and lifting both sides as shown. [. . . ] Line up tabs on front of base with slots inside the front cover. Replace cover screws and lower the pile height adjustment rollers into place. Replace light bulb and cover. EG1200 Explosion & Parts List 56 Illustration H-P Part # # 10 12 13 14 15 16 17 18 19 20 21 22 23 24 25 27 28 29 30 31 32 33 34 35 36 37 38 47 55 56 8581-01 8973 8974 8975 7941 7967 8978 8979 8980 8981 8982 8983 8984 8985 8986 8988 8989 7951 8991 8992 8993 8994 8995 8996 8997 8998 8999 7939 7958 7966 Belt Description Nozzle Base Motor Motor Bracket Overload Protector Bulb, light (15 Watt) Bulb Socket Catch, Yoke Swivel Bumper Roller Shaft Seal, Yoke Bearing Nozzle Wheel Screw, Base Axle Roller Brush Assembly Seal, Motor Shaft Ratchet Catch Belt Guard Lens, Light Panel Cord Panel Light (includes item 31) Floor Nozzle, Upper Swivel Cap Indicator Cam Overload Seal On-Sert Lifter Screw, 8-18 x 1-1/2 Wire Connector LIMITED WARRANTY H-P PRODUCTS, INC. warrants that the EG1200 Electric Powerhead, when used for household purposes, pursuant to Seller’s instructions, will be free from defects in materials and workrkmanship for a period of one (1) year from the date of the initial consumer purchase. [. . . ]