User manual DIRT DEVIL POWERSWEEP

[. . . ] Do not use extension cords or outlets with inadequate current carrying capacity. Turn off all controls before unplugging. To unplug, grasp the plug, not the cord. Do not handle plug or vacuum cleaner with wet hands. [. . . ] Avoid picking up hard or sharp objects with the powerhead to prevent bag tears, hose clogs, and fan blade breakage with subsequent motor damage. BEFORE YOU PLUG IN YOUR POWERHEAD, check the voltage rating plate located underneath the Powerhead to check if it agrees within 10% of the voltage available. The motor in your new Powerhead is permanently lubricated and sealed. Do not oil the motor at any time. RATING PLATE The model, type, and serial numbers are indicated on the rating plate. For prompt and complete service information, always refer to these numbers when inquiring about service. AMPS HERTZ VOLTS TYPE & SERIAL MODEL 3 HOW TO ASSEMBLE THE POWERHEAD 1. Snap together the two interlocking wands. Push assembled wands into powerhead socket. Place cord between cord guides on handle socket, as shown, and turn to position. Press cord into channels on wands. 4 Attaching Unit to Wands 1 Snap wands together. 3 Push plug into retainer; secure cord in slot and cord channel. 4 Place hose handle into wands until plug connects and button locks. 5 Step on motorized nozzle; pull back on handle. 6 Select bare floor or carpet cleaning. Cord Holder 5 POWERHEAD BRUSH ROLL BELT Your motor driven powerhead uses a belt to transfer power from the electric motor to the revolving brush roll. One of the safety features in your powerhead is a design to let the belt slip if something becomes caught in the brush roll. One result of this slip feature is belts that require occasional replacement. The length of time between replacements will vary based on your specific usage. Should you notice a reduction in cleaning, replace the belt. Powerhead belts are not replaced under warranty, since they are designed to slip rather than permit damage to the motor. Edge Cleaner EDGE CLEANER feature provides for improved cleaning of carpets near walls and stationary furniture. Slots on the sides of the nozzle increase air flow to the edges of the powerhead and add to the cleaning efficiency of the powerhead. To operate, simply run powerhead along edge board. [. . . ] Remove the broken or worn belt and replace it with a new belt. Replace the brush cover, aligning the two U-shaped slots in the brush cover with the center screw housings. 6. Then replace the upper housing by hooking the projection on the front side of the upper housing to the lower housing and securing it with the two screws. U-shaped slots Screws 8 LIMITED WARRANTY H-P PRODUCTS, INC. warrants that the PowerSweep® Electric Powerhead, when used for household purposes, pursuant to Seller's instructions, will be free from defects in materials and workmanship for a period of one year from the date of the initial consumer purchase. [. . . ]