User manual DIRTDEVIL M076613 3-96

[. . . ] Keep hair, loose clothing, fingers, and all parts of body away from openings and moving parts. Turn off all controls before unplugging. Do not use to pick up flammable or combustible liquids such as gasoline or use in areas where they may be present. Look on your vacuum cleaner and follow all label and marking instructions. [. . . ] ABOVEFLOOR CLEANING: Cleaner must be i n the locked upright position to lilt the rotating brush off the carpet when cleaning above the floor. Pull the hose handle from side of cleaner, (Diagram 9). Choose any of the handy accessories or use the hose alone. Simply push the attachment firmly onto the end of the wand or hose handle, (Diagram 11). It converts easily into an upholstery tool by sliding off the bristle strip. Additional extension wands are available from an authorized Royal Dealer or the enclosed quick parts mailer. To remove a tool or wand, twist and pull the two apart gently. Level carpet low pile height and kitchen type LOW caroet hard surface AUTO bare floors HOW TO TRANSPORT CLEANER: TO move your cleaner, put in the upright position, tilt cleaner back on the wheels and push or pull. The cleaner can also be moved by using the carrying handle on the back of the cleaner. (Diagram 1) CARPET SETTINGS (not available on all models): Lower the handle by activating the handle release pedal with your foot. The settlng should be low enough for effectlve cleanmg, yet h ~ g h enough that the cleaner IS not dlfflcult to push. (D~agram 2) NOTE: If cleaner is difficult to push, adjust to a higher carpet setting height. If there is suction at the end of the hose, a clog may be in the base of the unit. If this happens, the nozzle guard should be removed to clean the air passage. If there is not suction at the end of the hose, there is a clog in the hose. If there is a clog in the hose, remove the hose from the handle base by pushing in the pin on the short end of the flexible hose and gently clear the blockage. Cleaner must have paper bag i n place at all times. Check to be sure your upright has one paper bag in place before you begin vacuuming. Change your bag when you experience low performance with the upright. Do not exceed marked fill line on paper bag. Pull release lever and pull front panel off, (Diagram 3). REMOVE: Grasp cardboard collar of paper bag with both hands and pull past raised locking tabs on the dirt tube. [. . . ] Press firmly on entire nozzle guard to fit into place, (D~agram IMPORTANT: Rotate brush roll by hand before starting cleaner. Power cord not firmly plugged into outlet 2. Take to service center or call 1-800-321-1134. 4 Replace paper bag - Pg: 4 Review paper bag installation - Pg. [. . . ]