User manual DIRTDEVIL PD20020

[. . . ] Let us help you put your product together or answer any questions, call: Please read these instructions carefully before using your product. Hint: Attach your sales receipt to this Owner's manual. Verification of date of purchase may be required for warranty service of your Dirt Devil® product. Product assembly may include small parts. [. . . ] If you are not near a Warranty Station, call the factory for assistance at USA & Canada: 1-800-321-1134. use only genuine Royal ® replacement parts. The warranty does not include unusual wear, damage resulting from accident or unreasonable use of the vacuum cleaner. This warranty does not cover brushes, bags, flat belts, filters and bulbs. This warranty does not cover unauthorized repairs. This warranty gives you specific legal rights and you may also have other rights (Other rights may vary from state to state in the USA). Main body Main on/off button Red On light Green pilot light indicating steam ready Steam flow regulator control Safety stopper Horizontal parking groove Accessory Holder Wheels Extension tube support (parking vertical) Steam plug Steam gun Main steam nozzle Steam release button Steam release blockage button Button for connection/ disconnecting accessories Extension tubes Buttons for attaching/detaching the extension tubes Power cable Pad connector Pad Flaps holding pad cloth Never leave the appliance plugged in when filling or emptying. ⷠUnscrew Safety Stopper (F) by pressing down and turning slightly in a counter-clockwise direction (Fig. NOTE: In hard water areas, or to prevent calcium and mineral deposits from accumulating on the heating element and mop head, you may use distilled or demineralized water in place of tap water. ⷠPour in water using the measuring cup and funnel supplied. This will switch on red pilot light (C)(Fig. Put steam gun (L) in place, attaching it to the base using steam plug (K)(Fig. Wait for green steam ready light (D) to come on (Fig. At that moment, the steamer is ready to be put into operation. Press steam release button (N), making sure that steam release button (O) is not jammed (Fig. NOTE: When pressing steam release button (N) for the first time or after a certain amount of time out of use, a few drops of water may form due to the initial heat instability. This is normal and is simply caused by steam condensation in the conducts. If this occurs, it is advisable to release the steam into a cloth, keeping steam release button (N) pressed and then wait a few seconds until the droplets disappear. Switch off the appliance by pressing the general on/off button (B), ensuring that the red pilot light has gone off and then unplug the power supply cable from outlet. ⷠEliminate the steam pressure, pressing steam release button (N). ⷠSlowly unscrew the safety stopper (F) to enable the remaining steam that might be in the water to be released slowly. ⷠWait a few moments and then slowly pour in 1. [. . . ] ⷠUse Pad (U) with Pad cloth (W) to clean delicate surfaces (wood, parquet), and to dry the surface being cleaned when using the steamer. WARNING: Never leave the pad in one spot on any surface for an extended period of time with a damp or wet microfibercleaning pad attached as this may damage the floor surface. CAUTION: Never use the pad on surfaces that are prone to scratching, unless using pad cloth. cAUTION: The pad emits steam and creates moisture. [. . . ]