User manual DISCOVERY CHANNEL STX7000

[. . . ] Indd 1 2012-02-13 �� 9:36:22 ALIGNMENT AND ADJUSTMENTS WARNING To avoid risk of electrical shock, personal injury or death; disconnect power to washer before servicing, unless testing requires power. GENERAL ERROR FUNCTION NO Error Code (Diagnostic Code Error Image) nd Description Corrective Action 1 The water level fails to drop below the Go to “ Will Not Drain” Troubleshooting Reset Water Level within 30 minutes. 3 nF When the filling Continues for more Go to “ No Water Fill” Troubleshooting than 60 minutes or there is no change Section. 4 FL 5 LE A water level lower than the Reset water level is detected for 5 seconds during the Wash/Rinse cycle. [. . . ] Indd 7 2012-02-13 �� 9:36:24 ALIGNMENT AND ADJUSTMENTS WARNING To avoid risk of electrical shock, personal injury or death; disconnect power to washer before servicing, unless testing requires power. cycle Count Check Mode Definition of Cycle Count Check Mode: - Cycle Count Check Mode is to tally up the number of washings. How to Enter: - To enter the Cycle Count Check Mode, press the Signal Key during Service Mode. When the Signal key is pressed, the total number of washings will light up and a signal LED will glow. The maximum number of cycles will be 1999. The counter will roll over to 0 and start counting again after 1999. The counting will be carried out at the end of the normal cycle. (For normal and Continuous Run cycles, the count is carried out at the end of the cycles. To exit the Cycle Count Check Mode, press the “Signal” key again. s/W Version Check Mode Definition of S/W Version Check Mode: - S/W Version Check Mode is to bring up S/W Version information. How to Enter: - To enter the S/W Version Check Mode, press the Soil Level Key during Service Mode. How to Enter: - To enter the Diagnostic Code Check Mode with code “d” flashing, press the Spin key during Service Mode. Press the “Spin key” key to start Error Code Check Mode with Code “d” flashing. To cycle through the error codes, turn the Rotary Cycle Selector in one direction (either Clockwise or Counterclockwise). Now, when turning the Rotary Selector Key in the same direction, it shows error codes from the latest. When turning it in the opposite direction, it shows the error codes in the reverse order. spin Diagnostic Code 11 STX7000_03051A-02(Technical information). Indd 11 2012-02-13 �� 9:36:25 ALIGNMENT AND ADJUSTMENTS WARNING To avoid risk of electrical shock, personal injury or death; disconnect power to washer before servicing, unless testing requires power. Demo Mode - Demo mode is entered when the Pure Cycle + Extra Rinse buttons are held down for five (5) seconds simultaneously in the power on state. - When entering Demo mode, the buzzer rings three (3) times and “- - - -” is displayed on the 7 segment display and all other LEDs are turned off. (Initial Demo mode) - Demo mode consists of WASH , SPIN and LED modes. - If the Temp button is pressed during the initial Demo mode, “WASH” blinks on the 7 segment display and the washing machine enters WASH mode. [. . . ] €¢ Check for any restriction in the drain hose. €¢ Close the door and press the Start/Pause Button. For safety reasons, the washer does not tumble or spin with the door open. €¢ When it is freezing outside, check if it is frozen inside the drain hose. [. . . ]