User manual DOD BASSTEC

[. . . ] · operation of this unit within significant electromagnetic fields should be avoided. OPERATING THE BASSTEC PLUG IN, TURN ON, ROCK OUT. Selecting programs Use either the footswitches (1), or the bank/edit buttons (7). The first three footswitches select programs, the last footswitch selects banks. To select a specific bank, continue stepping on bank footswitch until the desired bank number appears in display (5). Then step on footswitch 1-3 to activate program. [. . . ] Hold down both the Compressor and Reverb buttons while powering up the BASSTEC. The BASSTEC has now reverted to factory default. Accessories for the BASSTEC Gig Bag DOD Electronics 8760 South Sandy Parkway Sandy, Utah, 84070 Telephone (801) 566-8800 FAX (801) 566-7005 International Distribution: 3 Overlook Drive, Unit 4 Amherst, New Hampshire 03031 U. S. A. FAX (603) 672-4246 BASSTEC is a registered trademark of DOD Electronics Copyright © 1997 DOD Electronics Printed in U. S. A. BASSTEC VCC1 Volume/Continuous Controller DECLARATION OF CONFORMITY Manufacturer's Name: DOD Electronics Corporation Manufacturer's Address: 8760 S. Sandy Parkway Sandy, Utah 84070, USA declares that the product Product Name: BASSTEC Product Options: All conforms to the following product specifications: Safety: EN 60065 (1993) IEC63 (1985) with Amendments 1, 2, 3 EN 55013: (1990) EN 55020: (1991) EMC: Supplementary Information: The product herewith complies with the requirements of the Low Voltage Directive 73/23/EEC and the EMC Directive 89/336/EEC as ammended by directive 93/68/EEC. DOD Electronics Corporation President of DOD 8760 S. Sandy Parkway Sandy, Utah 84070, USA Effective: 8/26/97 European Contact: Your Local DOD Sales and Service Office or International Sales Office 3 Overlook Drive #4 Amherst, New Hampshire 03031, USA Tel (603) 672-4244 Fax (603) 672-4246 Warranty 1. The warranty registration card must be mailed within ten days after purchase date to validate this warranty. DOD warrants this product, when used solely within the U. S. , to be free from defects in materials and workmanship under normal use and service. DOD liability under this warranty is limited to repairing or replacing defective materials that show evidence of defect, provided the product is returned to DOD WITH RETURN AUTHORIZATION, where all parts and labor will be covered up to a period of one (1) year. A Return Authorization number may be obtained from DOD by telephone. The company shall not be liable for any consequential damage as a result of the product's use in any circuit or assembly. Proof-of-purchase is considered to be the burden of the consumer. DOD reserves the right to make changes in design or make additions to or improvements upon this product without incurring any obligation to install the same on products previously manufactured. BT MULTI EFFECTS PROCESSING 4 5 6 INPUT, OUTPUT, 7 AND ALL THOSE FUNKY 3 2 8 9 10 11 1 1. Program and bank selector footswitches These footswitches provide access to the BASSTEC's banks/programs. Power adapter input This is where the DOD PS200R power supply is connected. Use only the DOD PS200R, other adapters will damage the BASSTEC, and void the warranty. Mix/Wah/Volume/Sensitivity control input Connect optional DOD VCC1 to have real time control over volume levels, wah ranges, fx mix, and auto wah sensitivity. Effect selector buttons These buttons allow you to select the effects you wish to use or bypass. Display The LED display in program mode shows which bank and program is currently selected. In Edit mode it shows the number and/or status of the selected effect. In Tuner mode it displays the note currently being played. [. . . ] 250ms, increasing feedback and delay mix. 400ms, increasing feedback and delay mix. 100ms, increasing feedback and delay mix. 250ms, increasing feedback and delay mix. [. . . ]