User manual DOD FX55C

[. . . ] TONE: Modifies the tone or sound of only the distortion signal. When the TONE control is straight up, the distortion signal is unchanged. [. . . ] In setting up the effect, use the LEVEL control to match the level of the output distortion effect with the level of the original input signal, so that when the effect is switched in and out, no difference in gain is noticeable. The FX55C Supra Distortion The FX55C's distortion is a symmetrical standard distortion sound with a boost of gain in its upper range. The GAIN control generates an extremely wide range of distortion sounds. Turning the GAIN control clockwise increases the amount of distortion. The basic sound of the distortion can be greatly changed and enhanced with the TONE control. Turning the TONE control counterclockwise from center boosts the low frequencies. Turning the TONE control clockwise from center boosts the high frequencies. DARK-N-CRUNCHY Use this setting to complement a single coil equipped guitar. Great for heavy low-note riffs. CONNECTING THE 55B Connect the INPUT of the FX55C to your guitar with a 1/4-inch mono phone plug. Connect the OUTPUT of the FX55C to your amplifier (or to the input of the other effects if you're using them) with a 1/4-inch mono phone plug. To elminate the need for a 9 volt battery, attach the DOD PS200R power supply to the A. C. adapter jack. RAW BONES Use this setting with chords for a biting edge type sound in power chords. FEATURES The FX55C Supra Distortion also features: FET Switching for "Clickless" insertion into the signal path. LED indicator shows the status of the effect and battery condition. [. . . ] The warranty registration card must be mailed within ten days after purchase date to validate this warranty. DOD Warranty Product Options: All (requires a Class II power adapter that conforms to the requirements of EN 60065, EN 60742, or equivalent). The product herewith complies with the requirements of the Low Voltage Directive 73/23/EEC and the EMC Directive 89/336/EEC as amended by directive 93/68/EEC. Manufacturer's Name: DOD Electronics Corporation Copyright © 1998 DOD Electronics Corporation Printed 2/98 FX55C 18-1055-A Manufacturer's Address: 8760 S. Sandy Parkway Sandy, Utah 84070, USA European Contact: Your Local DOD Sales and Service Office or Safety: EN 60065 (1993) IEC65 (1985) with Amendments 1, 2, 3 International Sales Office 3 Overlook Drive #4 Amherst, New Hampshire 03031, USA Tel (603) 672-4244 Fax (603) 672-4246 DECLARATION OF CONFORMITY International Distribution 3 Overlook Drive Unit 4 Amherst, New Hampshire 03031 U. S. A. [. . . ]