User manual DOD FX59

[. . . ] Care should be taken so that objects do not fall and liquids are not spilled into the enclosure through openings. POWER SOURCES: The appliance should be connected to a power supply only of the type described in the operating instructions or as marked on the appliance. GROUNDING OR POLARIZATION: Precautions should be taken so that the grounding or polarization means of an appliance is not defeated. POWER CORD PROTECTION: Power supply cords should be routed so that they are not likely to be walked on or pinched by items placed upon or against them, paying particular attention to cords at plugs, convenience receptacles, and the point where they exit from the appliance. [. . . ] We always provide more for less. 3 FUNCTIONS 4 5 67 8 9 10 3 2 11 12 1 FUNCTIONS 1. Program and Bank Selector Foot switches: These foot switches provide access to the TEC4's banks/programs. Power Adapter Input: This is where the PS200R power supply is connected. Use only the DOD PS200R, other adapters may damage the TEC4, and void the warranty. Volume/Wah/Sensitivity Control Input: Connect optional DOD VCC1 to have real time control over volume levels, wah ranges, and auto wah sensitivity. Effect Selector Buttons: These buttons allow you to select the effects you wish to use or bypass. LED Display: The LED display in program mode shows which bank and program is currently selected. In Edit mode it shows the number and/or status of the selected effect. In Tuner mode it displays the note currently being played. Store and User LEDs: The Store LED indicates that a change has been made to a preset. The User LED indicates whether you are in user, or factory banks. This is the TEC4 asking where you would like to save the program. Use the Up/Down Buttons (8) to select desired program number and press the Store Button (7) one more time to save. The FX59 provides 30 User program locations for you to fill with programs of your own. You can also copy a program to a new location by pressing the Store Button (7) once and using the Up/Down Buttons (8) to select a new User program location and then pressing the Store Button (7) again. BYPASSING To bypass the current program, press the foot switch (1) of the program you are currently using . "bp" will appear in the LED display (5). To exit program bypass, press any foot switch. TUNER ACTIVATION To activate tuner, press and hold the foot switch (1) of the program you are currently using for approximately 2 seconds. "tu" will appear in the LED display (5). To tune, pluck a string repeatedly (a harmonic at the 12th fret is sometimes works best). The LED Display will show the note being tuned while the the second vertical row of Effect LEDs will show the tuning status of the note. The note is in tune when the green LED is lit. LEDs lit above the green LED indicate the note is sharp. [. . . ] PITCH SHIFTER: Creates a harmony with the original signal, and then mixes the two together. DETUNE: Creates a duplicate of the original signal then delays and detunes it slightly. WAH: Creates a filter that is swept manually through the signal. AUTO WAH: Sweeps a filter through the signal according to the strength of the attack. [. . . ]