User manual DOD SR606

[. . . ] Grounding or Polarization: Precautions should be taken so that the grounding or polarization means of an appliance is not defeated. Power Cord Protection: Power supply cords should be routed so that they are not likely to be walked on or pinched by items placed upon or against them, paying particular attention to cords at plugs, convenience receptacles, and the point where they exit from the appliance. Servicing: To reduce the risk of fire or electrical shock, the user should not attempt to service the appliance beyond that described in the operating instructions. All other servicing should be referred to qualified service personnel. [. . . ] Before continuing any further, please make sure the following items have been included: 1 SR606 1 Owners Manual 1 Warranty Card 1 Detachable Power Cord Please take a moment to fill out the warranty card. It is your safe guard in the unlikely event that your unit requires servicing. Please save all packing materials and use these materials to return the product if servicing is required. 1 2 SR606 FRONT PANEL 3 1 2 4 5 6 1. Master Input Level - Controls the signal strength entering the Left and Right Inputs. Channel 1-6 Level - Controls the signal strength entering the 1-6 inputs, being delivered to the 1- 6 Outputs, or being delivered to the Left and Right Outputs, depending on your application. Channel 1-6 Pan - Controls the Left/Right position being delivered from Channels 1-6 to the Stereo Outputs, or Selects which Stereo Input Channel 1-6 is receiving its signal from. Master Output Level - Controls the signal strength being delivered to the Left and Right Outputs. Clip LEDs - These LEDs light 3 dB before clipping occurs at the Left or Right Outputs only. NOTE: The clip indicators will only register clipping at the outputs. They will not register a clip at any other point in the unit. Power Switch - Used to engage or disengage the power to the SR606. SR606 REAR PANEL 4 3 1 2 3 5 6 1. Power Receptacle - Connect the detachable Power cord from here to an AC outlet 2. Main Output - These Left and Right Outputs can receive signal from the Left and Right Inputs, or the Channel 1-6 Inputs, or a combination, depending on your application. Channel 1- 6 Outputs - The Channel 1-6 Outputs can receive signal from the Main Inputs, or from the Channel 1- 6 Inputs, or a combination, depending on your application. Channel 1 - 6 Mix/Dist Switch - These switches selects individual Channels of the SR606 to be used as a distribution amp, or as a line mixer. When the switches are depressed, the SR606 will act as a distribution amp. When the switches are not depressed, the SR606 will act as a line mixer. NOTE: If using the SR606 as a line mixer, make sure that all switches are out. This will prevent the unit from self oscillating. Channel 1 - 6 Inputs - These are the Inputs for Channel's 1 - 6, which can be routed to the Left and Right Outputs, or the Channel 1- 6 Outputs, or a combination, depending on your application. Main Inputs - These Left and Right Inputs can deliver their signal to the Channel 1 - 6 Outputs, the Left and Right Outputs, or a combination, depending on your application. 4 SR606 INSTALLATION Install the SR606 in a rack with the provided rack screws. [. . . ] 90dB to mix outputs 108dB DOD WARRANTY 1. The warranty registration card must be mailed within ten days after purchase date to validate this warranty. DOD warrants this product, when used solely within the U. S. , to be free from defects in material and workmanship under normal use and service. DOD Electronics liability under this warranty is limited to repairing or replacing defective materials that show evidence of defect, provided the product is returned through the original dealer, where all parts and labor will be covered up to a period of three (3) years. [. . . ]