User manual DOD VOTEC

[. . . ] · operation of this unit within significant electromagnetic fields should be avoided. OPERATING THE VoTEC PLUG IN, TURN ON, ROCK OUT. Selecting programs To select programs use either the footswitches (1), or the Up/down buttons (9). The first three footswitches select programs, the last footswitch selects banks. To select a specific bank, continue stepping on bank footswitch until the desired bank number appears in display (5). [. . . ] VoTEC Manufacturer's Name: DOD Electronics Corporation Manufacturer's Address: 8760 S. Sandy Parkway Sandy, Utah 84070, USA declares that the product Product Name: VoTEC Product Options: All (requires a Class II power adapter that conforms to the requirements of EN 60065, EN 60742, or equivalent). Safety: EN 60065 (1993) IEC65 (1985) with Amendments 1, 2, 3 EN 55013: (1990) EN 55020: (1991) EMC: Supplementary Information: The product herewith complies with the requirements of the Low Voltage Directive 73/23/EEC and the EMC Directive 89/336/EEC as amended by directive 93/68/EEC. DOD Electronics Corporation President of DOD 8760 S. Sandy Parkway Sandy, Utah 84070, USA Effective: February 23, 1998 European Contact: Your Local DOD Sales and Service Office or International Sales Office 3 Overlook Drive #4 Amherst, New Hampshire 03031, USA Tel (603) 672-4244 Fax (603) 672-4246 Warranty 1. The warranty registration card must be mailed within ten days after purchase date to validate this warranty. DOD warrants this product, when used solely within the U. S. , to be free from defects in materials and workmanship under normal use and service. DOD liability under this warranty is limited to repairing or replacing defective materials that show evidence of defect, provided the product is returned to DOD WITH RETURN AUTHORIZATION, where all parts and labor will be covered up to a period of one (1) year. A Return Authorization number may be obtained from DOD by telephone. The company shall not be liable for any consequential damage as a result of the product's use in any circuit or assembly. Proof-of-purchase is considered to be the burden of the consumer. DOD reserves the right to make changes in design or make additions to or improvements upon this product without incurring any obligation to install the same on products previously manufactured. The foregoing is in lieu of all other warranties, expressed or implied, and DOD neither assumes nor authorizes any person to assume for it any obligation or liability in connection with the sale of this product. In no event shall DOD or its dealers be liable for special or consequential damages or from any delay in the performance of this warranty due to causes beyond their control. MULTI EFFECTS PROCESSING 4 5 6 7 INPUT, OUTPUT, AND ALL THOSE FUNKY 3 2 8 9 10 11 12 13 BUTTONS. 1. Program and bank selector footswitches These footswitches provide access to the User banks/programs. Power adaptor input This is where the DOD PS200R power supply is connected. [. . . ] Detune, 3@5 cents, 3@10 cents, 3@15 cents. Wah, ranges 1-3 Auto Wah, ranges 1-3 Band Pass Filter Enveloped FX, 5 flanger, 5 phaser Delay: 01-99 Mono 01-59 Multitap 60-99 100ms to 500ms increasing in 100ms steps, increasing feedback and delay mix. 100ms to 500ms increasing in 100ms steps, increasing feedback and delay mix. Reverb: 1-9 1-3: 4-6: 7-9: Room, 3 levels. [. . . ]