User manual DOLMAR AG-3628

[. . . ] The blower is not intended for use by young children or infirm persons without supervision. Young children should be supervised to ensure that they do not play with the blower. WARNING: DO NOT let comfort or familiarity with product (gained from repeated use) replace strict adherence to safety rules for the subject product. [. . . ] Always switch off the tool before installing or removal of the battery cartridge. To remove the battery cartridge, withdraw it from the tool while sliding the button on the front of the cartridge. To insert the battery cartridge, align the tongue on the battery cartridge with the groove in the housing and slip it into place. Always insert it all the way until it locks in place with a little click. If you can see the red part on the upper side of the button, it is not locked completely. Insert it fully until the red part cannot be seen. If not, it may accidentally fall out of the tool, causing injury to you or someone around you. Do not use force when inserting the battery cartridge. If the cartridge does not slide in easily, it is not being inserted correctly. The battery cartridge is equipped with the protection system, which automatically cuts off the output power for its long service life. The tool may stop during operation when the tool and/or battery are placed under the following situation. This is caused by the activation of protection system and does not show the tool trouble. When the tool is overloaded: At this time, press the "OFF" button and remove causes of overload and then press the "HIGH/LOW" button again to restart. When the tool does not work even after pressing the "HIGH/LOW" button, the battery power auto-stop is still at work. Always stop tool operation and charge the battery cartridge when you notice less tool power. The first press on this button is for high speed and the second press for low speed and then each press on this button repeats the high/low speed cycle alternatively. [. . . ] If you need any assistance for more details regarding these accessories, ask your local Dolmar service center. Are of series production and Conforms to the following European Directives: 2000/14/EC, 2006/42/EC And are manufactured in accordance with the following standards or standardized documents: EN15503 The technical documentation is on file at: Dolmar GmbH, Jenfelder Straße 38, Abteilung FZ, D-22045 Hamburg The conformity assessment procedure required by Directive 2000/14/EC was in Accordance with annex V. Noise The typical A-weighted noise level determined according to EN15503: Sound pressure level (LpA): 81. [. . . ]