User manual DOLMAR AH-3655

[. . . ] Grooves Press the hooks on both sides Unlock the hooks Blade cover Screws Under cover Plate Crank Oval hole of shear blade Limit mark Holder cap cover Screwdriver Brush holder cap Model Blade length Strokes per minute (min-1) Overall length Net weight Rated voltage 1, 070 mm 5. Due to our continuing programme of research and development, the specifications herein are subject to change without notice. Specifications may differ from country to country. Weight according to EPTA-Procedure 01/2003 Symbol END013-2 The following show the symbols used for the equipment. [. . . ] Do not use force when inserting the battery cartridge. If the cartridge does not slide in easily, it is not being inserted correctly. The strokes per minute can be adjusted just by turning the adjusting dial. This can be done even while the tool is running. the dial is marked 1 (lowest speed) to 6 (full speed). Refer to the table below for the relationship between the number settings on the adjusting dial and the strokes per minute. The battery cartridge is equipped with the protection system, which automatically cuts off the output power for its long service life. The tool may stop during operation when the tool and/or battery are placed under the following situation. This is caused by the activation of protection system and does not show the tool trouble. When the tool is overloaded: At this time, release the switch trigger and remove causes of overload and then pull the switch trigger again to restart. When the tool does not work even after pulling the switch trigger, the battery power autostop is still at work. The speed adjusting dial can be turned only as far as 6 and back to 1. Do not force it past 6 or 1, or the speed adjusting function may no longer work. Always be sure that the tool is switched off and the battery cartridge is removed before carrying out any work on the tool. Before using battery adapter, read all instructions on tools using battery. When charging a battery cartridge, first remove it from the battery adapter and then charge it. It is not allowed to charge the battery cartridge while using battery adapter. installing or removing battery adapter · Always switch off the tool before insertion or removal of the battery adapter. To remove the battery adapter, withdraw it from the tool while sliding the button on the adapter. To insert the battery adapter, align the tongue on the battery adapter with the groove in the housing and slip it into place. Always insert it all the way until it locks in place with a little click. If you can see the red part on the upper side of the button, it is not locked completely. [. . . ] Store the tool out of the reach of children carefully. store the tool in the place not exposed to water and rain. To maintain product SAFETY and RELIABILITY, repairs, any other maintenance or adjustment should be performed by Dolmar Authorized Service Centers, always using Dolmar replacement parts. Be careful not to get your hands dirty as grease is applied in the shear blade driving area. [. . . ]