User manual DOLMAR AS-3625

[. . . ] 1 2 3 4 5 6 7 8 9 10 11 12 13 14 Lever Front hand guard Top handle Battery cartridge Carabiner or rope attachment point Guide bar Saw chain Sprocket cover Chain cover Lock off button Switch trigger Front handle Serrated rail (claw stop) Battery cover Be sure that you understand their meaning before use. Wear a helmet, goggles and ear protection. Hold the saw with both hands while working!Saw chain oil adjustment Réglage d'huile de la chaîne Sägekettenöleinstellung Regolazione olio catena sega Afstelling voor zaagkettingolie Ajuste del aceite de la cadena de sierra Regulação da lubrificação da corrente da electroserra Justering af savkædeolie Only for EU countries Do not dispose of electric equipment or battery pack together with household waste material! [. . . ] Check the amount of remaining oil in the oil tank through the oil inspection window. To refill the tank, remove the cap from the oil tank opening. After refilling the tank, always screw the provided oil tank cap on the chain saw. cAUTION: · When filling the chain saw with chain oil for the first time, or refilling the tank after it has been completely emptied, add oil up to the bottom edge of the filler neck. The oil delivery may otherwise be impaired. As a saw chain oil, use oil exclusively for DOLMAR chain saws or oil available in market. Never use oil including dust and particles or volatile oil. When pruning trees, use botanical oil. Never force the chain saw when pruning trees. Before cutting out, make sure that the provided oil tank cap is screwed in place. Start it and wait until lubrication on saw chain is adequate. Bring the lower guide into contact with the branch to be cut before switching on. Cutting without bringing the lower guide into contact with the branch may cause the guide bar to wobble, resulting in injury to operator. Saw the wood to be cut by just moving it down. Always be sure that the tool is switched off and the battery cartridge is removed before installing or removing the saw chain. Always wear gloves when installing or removing the saw chain. To remove the saw chain, slightly slide the lever in the direction of arrow so that it can be released from the locked position and move the lever in the upright position as shown in the figure. 6) Press the lever and with the lever pressed in, turn it counterclockwise to loosen the nut until sprocket cover comes off. 7) Turn the adjusting dial counterclockwise to release the saw chain tension. Remove the saw chain and guide bar from the chain saw. To install the saw chain, fit in one end of the saw chain on the top of the guide bar and the other end of it around the sprocket. 23) With the saw chain running, saw into the wood, using the top handle to raise the saw and the front one to guide it. [. . . ] Remove oil from the oil tank to empty it and place the chain saw. To maintain product SAFETY and RELIABILITY, repairs, any other maintenance or adjustment should be performed by DOLMAR Authorized Service Centres, always using DOLMAR replacement parts. Chips and sawdust will build up in the guide bar groove, clogging it and impairing oil flow. Always clean out the chips and sawdust when sharpening or replacing the saw chain. [. . . ]