User manual DOLMAR EC-1235

[. . . ] Avoid body contact with grounded surfaces such as pipes, radiators, ranges and refrigerators. There is an increased risk of electric shock if your body is grounded. Do not expose power tools to rain or wet conditions. Water entering a power tool will increase the risk of electric shock. [. . . ] DO NOT let comfort or familiarity with product (gained from repeated use) replace strict adherence to cutter safety rules. If you use this tool unsafely or incorrectly, you can suffer serious personal injury. A guard protects operator from broken wheel fragments. Accessories must be rated for at least the speed recommended on the tool warning label. Wheels and other accessories running over rated speed can fly apart and cause injury. Hold tool by insulated gripping surfaces when performing an operation where the cutting tool may contact hidden wiring or its own cord. Contact with a "live" wire will make exposed metal 3 Always use safety glasses or goggles. Ordinary eye or sun glasses are NOT safety glasses. Check the wheel carefully for cracks or damage before operation. replace cracked or damaged wheel immediately. Run the tool (with guard) at no load for about a minute, holding tool away from others. if wheel is flawed , it will likely separate during this test. Use only flanges specified for this tool. be careful not to damage the spindle or the flange (especially the installing surface). Damage to these parts could result in wheel breakage. NEVER use tool with wood cutting blades or other sawblades. Do not wrap cord around your arm or wrist. If control of tool is lost, cord may become wrapped around you and cause personal injury. Make sure the wheel is not contacting the workpiece before the switch is turned on. Before using the tool on an actual workpiece, let it run for a while. Watch for vibration or wobbling that could indicate poor installation or a poorly balanced wheel. Hold the tool so that sparks fly away from you and other persons or flammable materials. [. . . ] Pick up an end of the dust cover slightly with hands so that brush holder cap appears. use a screwdriver to remove the brush holder caps. Take out the worn carbon brushes, insert the new ones and secure the brush holder caps. When you wish to perform cleaner operation, connect a vacuum cleaner to your tool. [. . . ]