User manual DOLMAR LT-210

[. . . ] Important: Read this instruction manual carefully before putting the String Trimmer into operation and strictly observe the safety regulations!Thank you very much for purchasing the DOLMAR String Trimmer. We are pleased to recommend to you the DOLMAR String Trimmer which is the result of a long development programme and many years of knowledge and experience. Please read this booklet which refers in detail to the various points that will demonstrate its outstanding performance. [. . . ] Be sure the bolts are tight, but do not over tighten. ­ Adjust the handle to the desired position over 200mm away from the rear grip (3) and tighten the three screws (2). To meet the applicable safety provisions, only the tool/protector combinations as indicated in the table must be used. Be sure to use genuine DOLMAR nylon cutting head. ­ If the nylon cutting head hits against a stone during operation, stop the engine and check the nylon cutting head immediately. Turn the machine upside down, and you can replace the nylon cutting head. ­ Insert the hex wrench provided through the hole in the head case and rotate the support washer until it is locked with the hex wrench (or the shaft is locked). Handling fuel Utmost care is required when handling fuel. fuel may contain substances similar to solvents. Refuel either in a well-ventilated room or outdoors. Do not inhale fuel vapors; avoid any contact of fuel or oil with your skin. Mineral oil products degrease your skin. If your skin comes in contact with these substances repeatedly and for an extended period of time, it will desiccate. in addition , allergic reactions mey occur. Eyes can be irritated by contact with oil. If oil comes into your eyes, immediately wash them with clear water. If your eyes are still irritated, see a doctor immediately! observe the Safety Instructions on page 4. Fuel and oil mixture The engine of the String trimmer is a high-efficiency two-stroke engine. It is run with a mixture of fuel and two-stroke engine oil. The engine is designed for unleaded regular fuel with a min. In case no such fuel is available, you can use fuel with a higher octane value. [. . . ] Bring your sales receipts indicating date of purchase for this engine. The dealer or service center authorized by MAKITA will perform the necessary repairs or adjustments within a reasonable amount of time and furnish you with a copy of the repair order. All parts and accessories replaced under this warranty become the property of MAKITA. WHAT IS NOT COVERED * Conditions resulting from tampering, misuse, improper adjustment (unless they were made by the dealer or service center authorized by MAKITA during a warranty repair), alteration, accident, failure to use the recommended fuel and oil, or not performing required maintenance services. [. . . ]