User manual DOLMAR MAXX PARTS LIST 2004-11

[. . . ] Environmental Protection Agency (EPA), and that the engine is free of defects in materials and workmanship which would cause this engine to fail to conform with EPA regulations during its warranty period. For the components listed under PARTS COVERED, the service dealer authorized by DOLMAR will, at no cost to you, make the necessary diagnosis, repair, or replacement necessary to ensure that the engine complies with applicable U. EMISSION COMPONENT DEFECT WARRANTY PERIOD The warranty period for this engine begins on the date of sale to the initial purchaser and continues for a period of 2 years. PARTS COVERED Listed below are the parts covered by the Emission Components Defect Warranty. [. . . ] Make sure the log will not roll down-hill. There is an extreme danger of kickback at this point. Extra caution must be taken to maintain control of the saw. To make the felling cut, follow the sectioning method described previously (fig. If you are inexperienced with a chain saw plunge-cutting should not be attempted. There is an extreme danger of kickback during the limbing operation. Be extremely cautious and avoid contacting the log or other limbs with the nose of the guide bar. Do not stand on a log while limbing it - you may slip or the log may roll. Shattered wood should be cut very carefully. Sharp slivers of wood may be caught and flung in the direction of the operator of the saw. Start limbing by leaving the lower limbs to support the log off the ground (fig. Torque at speed Limit speed Idling speed Coupling speed Sound Pressure Level at the operator`s ear at full load according to ANSI B 175. Load per ISO 8893 Fuel tank capacity Chain oil tank capacity Mixture ratio (fuel/two-stroke oil) - when using DOLMAR oil - when using other oils Chain brake Sprocket pitch Number of chain sprocket teeth Chain type (see the Extract from the spare-parts list) Pitch / Driving element strength Guide bar, length of a cut Guide-bar type (see the Extract from the spare-parts list) Weight (fuel tank empty, without chain and guide bar) cu. WARNING: This chain saw is capable of severe kickback that coult result in serious injury to the user. Do not operate this chain saw unless you have extraordinary cutting needs and experience and specialized training for dealing with kickback. Chain saws with significantly reduced kickback potential are available. Use the universal wrench delivered with the chain saw for the following works. Put the chain saw on a stable surface and carry out the following steps for mounting the guide bar and chain: CAUTION: Before doing any work on the guide bar or chain, always switch off the engine and pull the plug cap off the spark plug (see "Replacing the spark plug"). CAUTION: Start the chain saw only after having assembled it completely and inspected!Turn the chain adjusting screw (B/4) anti-clockwise until the pivot (B/5) is positioned approx. Put the chain (D/6) onto the sprocket (D/7) and insert it into the guide groove of the guide bar. Lead the chain (E/6) around the sprocket nose (E/8) of the guide bar. [. . . ] He will also have the spare part lists to determine the required spare part numbers, and will be constantly informed about the latest improvements and also about spare part innovations. Please, take in mind that in case foreign spare parts are used instead of original DOLMAR spare parts this will automatically invalidate the DOLMAR product guarantee. DOLMAR guarantees the highest quality and will therefore reimburse all costs for mending through replacement of damaged parts as a result of material or production faults, which occur within the guarantee time after purchase. Please, note that in some countries particular guarantee conditions may exist. [. . . ]