User manual DOLMAR PE-251

[. . . ] Important: Read this instruction manual thoroughly before using the Edging Trimmer and follow the safety regulations carefully. Be sure to keep this instruction manual for future reference. Thank you very much for choosing the DOLMAR Edging trimmer. We are pleased to offer you a product that is the result of an extensive development program and many years of knowledge and experience. [. . . ] Spindle speed Maximum spindle speed (corresponding) Maximum fuel consumption Maximum specific fuel consumption Idling speed Clutch engagement speed Carburetor Ignition system Spark plug Electrode gap Fuel Gear ratio mm kg L cc HP /min /min kg/h g/HPh /min /min type type type mm 2600 3600 WALBRO WYJ Solid state ignition NGK BMR7A 0. CAUTION: Before doing any work on the brush cutter, always switch off the motor and pull the spark plug connector off the spark plug. CAUTION: Start the brush cutter only after having assembled it completely. ­ Loosen the two bolts (1) and insert the main pipe (2) into the case clutch (3). If it is difficult to insert, turn the spline (4) a little and re-insert. ­Tighten the two bolts (1) uniformly on the right and left by Allen wrench supplied. Shift the swivel (7) and put the cable into the swivel. At this time, be careful that the round hole in the swivel is oriented toward the fitting at the inner wire end. Connect the switch cords to the two cords from the engine by inserting one into the other. CAUTION: Before doing any work on the Edging trimmer, always stop the engine and pull the spark plug connector off the spark plug. ­ Fix a barrier to the left side of the machine together with the handle for operator's protection. ­ Do not adjust position of the loop handle too close to the control grip. Keep not less than 250mm distance between the handle and the grip. (a distance collar is provided for this purpose. Utmost care is required when handling fuel. fuel may contain substances similar to solvents. Refuel either in a well ventilated room or outdoors. Do not inhale fuel vapors, avoid any contact of fuel or oil with your skin. Mineral oil products degrease your skin. If your skin comes in contact with these substances repeatedly and for an extended period of time, it will desiccate. in addition , allergic reactions may occur. Eyes can be irritated by contact with oil. [. . . ] For the components listed under PARTS COVERED, Makita Factory Service Center or service center authorized by MAKITA will, at no cost to you, make the necessary diagnosis, repair, or replacement necessary to ensure that the engine complies with applicable U. EMISSION COMPONENT DEFECT WARRANTY PERIOD The warranty period for this engine begins on the date of sale to the initial purchaser and continues for a period of 2 years. PARTS COVERED Listed below are the parts covered by the Emission Component Defect Warranty. Some of the parts listed below may require scheduled maintenance and are warranted up to the first scheduled replacement point for that part. [. . . ]