User manual DOLMAR PS-420 S SPARE PARTS LIST

[. . . ] Weight, with battery cartridge, according to EPTA-Procedure 01/2003 Symbols END008-1 The following show the symbols used for the equipment. Be sure that you understand their meaning before use. The distance between the tool and bystanders must be at least 15 m. Wear a helmet, goggles and ear protection. [. . . ] Easy cutting with almost no kickback is possible within a blade segment between 9 and 11 o'clock. Employ only the correct cutting tool for the job in hand. Thickness), perform the cutting work by swinging the equipment evenly in half-circles from right to left (similar to using a scythe). The condition of the equipment, in particular of the cutting tool of the protective devices and also of the shoulder harness must be checked before commencing work. Particular attention is to be paid to the cutting blades which must be correctly sharpened. Turn off the motor and remove the battery cartridge before carrying out maintenance, replacing/ sharpening cutting tools or cleaning the equipment or cutting tool. Check loose fasteners and damaged parts such as cracks in the cutting attachment. When not in use, store the equipment indoors in dry and high or locked-up place - out of the reach of children. Use only the manufacturer's recommended replacement parts and accessories. Have the equipment repaired only by our authorized service center. Keep handles dry, clean and free from oil and grease. If you can see the red part on the upper side of the button, it is not locked completely. Insert it fully until the red part cannot be seen. If not, it may accidentally fall out of the equipment, causing injury to you or someone around you. Always be sure that the equipment is switched off and the battery cartridge is removed before removing the weeds or similar entangled in the cutting tool that 11 Cannot be removed in spite of using the reversing switch. cAUTION: · Always check the direction of rotation before operation. Use the reversing switch only after the equipment comes to a complete stop. Changing the direction of rotation before the equipment stops may damage it. Depress the reversing switch lever from the A side for counterclockwise (normal) rotation or from the B side for clockwise (reverse) rotation. In the reversing mode, the equipment automatically stops in a short time after turned on. Two speed ranges can be preselected with the speed change switch. To change the speed range, turn the speed change switch lever so that it points toward "1" for low speed or "2" for high speed. [. . . ] 32) Press on the housing latches inward to lift off the cover, then take the spool out and remove the remaining nylon cord on it. 33) Hook the center of new nylon cord into the notch in the center of the spool, with one end of the cord extending about 80 mm more than the other. Then wind both ends firmly around the spool in the direction of the head rotation (left-hand direction indicated by LH and right-hand direction by RH on the side of the spool). 34) Wind all but about 100 mm (3-15/16") of the cords, leaving the ends temporarily hooked through a notch on the side of the spool. [. . . ]