User manual DOLMAR TM-92.14 H

[. . . ] Dear Customer, Thank you for having chosen one of our products. We hope that you will get complete satisfaction from using your new machine and that it will fully meet all your expectations. This manual has been compiled in order that you may get to know your machine and to be able to use it safely and efficiently. Don't forget that it forms an integral part of the machine, so keep it handy so that it can be consulted at any time, and pass it on to the purchaser if you resell the machine. [. . . ] If the malfunction continues, refer to chapter «7» of this manual and to the engine manual. Always bear in mind that the safety devices prevent the Engine from starting if safety requirements have not been met ( 5. In these cases, once the situation has been corrected, the key must first be turned back to «OFF» before the engine can be restarted. This machine has not been approved for use on public roads. It has to be used (as indicated by the highway code) in private areas closed to traffic. NOTE When moving the machine, the blades must be disengaged and the cutting deck put at its highest position (position «7»). Put the accelerator control between the «SLOW» and «FAST» positions, and the gear change lever in the 1st speed position ( 4. Keep the pedal pressed down and disengage the parking brake. Slowly release the pedal which will turn from «brake» to «clutch», thus operating the rear wheels ( 4. The pedal has to be released gradually as a sudden engagement may cause tipping up and loss of control of the vehicle. Gradually reach the desired operating speed using the accelerator and gear lever. To change the gear speed the clutch must be used pushing the pedal half way down ( 4. When moving the machine from one area to another, put the accelerator lever in a midway position between «SLOW» and «FAST». 32) in direction »F» and reach the required speed by progressively increasing pressure on the pedal and moving the accelerator appropriately. Drive must be engaged in the way already described ( 4. 32) to prevent sudden engagement from causing tipping up and loss of control of the vehicle, particularly on slopes. 31) to further reduce the speed until the machine stops. NOTE The machine already slows down considerably by just releasing the drive pedal. 4 REVERSE Reverse must be engaged ONLY when the machine is stopped. Push down the pedal until the machine stops and then go into reverse by moving the lever sideways and putting it into position «R» ( 4. Gradually release the pedal to engage the clutch and then begin moving in reverse. When the machine is stopped, start the reverse movement by pressing the drive pedal in the «R» direction ( 4. [. . . ] 25 A fuse (2) = protects the battery charger circuit. When it blows, the battery gradually runs out and the machine will have problems starting. IMPORTANT A blown fuse must always be replaced by one of the same type and ampere rating, and never with one of another rating. If you cannot find out why the fuse has blown, consult a Licensed Service Centre. [. . . ]