User manual DOLMAR WK-80 PARTS LIST 12-98

[. . . ] To safety obtain the possible possible result from your DOLMAR Edging trimmer, please read this manual thoroughly before using the machine, and follow all instructions given herein to assure proper operation of the DOLMAR Edging Trimmer. Please note the following symbols when reading the instructions manual. WARNING/DANGER Top permissible tool speed Before usage, carefully read and fully understand the instructions in this manual Wear protective shoes Recyclable Keep working area clear of persons and pets ON/START Wear a protective helmet and eye and ear protection ­ To ensure correct operation, user has to read this instruction manual to make himself familiar with the handling of the Edging trimmer. Users insufficiently informed will risk danger to themselves as well as others due to improper handling. [. . . ] Do not perform any modifications on the Edging trimmer as this will endanger your safety. The performance of maintenance or repair work by the user is limited to those activities as described in the instruction manual. All other work is to be done by an Authorized Service Agent. Use only genuine spare parts and accessories released and supplied by DOLMAR. Use of non-approved accessories and tools means increased risk of accidents. DOLMAR will not accept any liability for accidents or damage caused by the use of non-approved cutting blade and fixing devices of cutting blade, or accessories. In case of accident make sure that a first-aid box is available in the vicinity of the cutting operations. Immediately replace any item taken from the first aid box. When asking for help, please give the following information: Cardboard is a basic raw material and is therefore consequently reusable or suitable for recycling (waste paper recycling). Loop handle Dimensions : length x width x height (without cutting blade) Mass (without cutting blade) Volume (fuel tank) Engine displacement Maximum engine performance Engine speed at recommended max. Spindle speed Maximum spindle speed (corresponding) Maximum fuel consumption Maximum specific fuel consumption Idling speed Clutch engagement speed Carburetor Ignition system Spark plug Electrode gap Fuel Gear ratio mm kg L cc HP /min /min kg/h g/HPh /min /min type type type mm 2600 3600 WALBRO WYJ Solid state ignition NGK BMR7A 0. If your eyes are still irritated, see a doctor immediately. It is run with a mixture of fuel and two-stroke engine oil. The engine is designed for unleaded regular fuel with a min. In case no such fuel is available, you can use fuel with a higher octane value. This will not affect the engine, but may cause poor operating behaviour. A similar situation will arise from the use of leaded fuel. To obtain optimum engine operation and to protect your health and the environment, only unleaded fuel should be used!For lubricating the engine use a two-stroke engine oil (quality grade: TC-3), which is added to the fuel. The engine has been designed to use specified two-stroke engine oil at mixture ratio of 50:1 to protect the environment. In addition, a long service life and a reliable operation with a minimum emission of exhaust gases is guaranteed. It is absolutely essential to observe a mixture ratio of 50:1 (specified 2-stroke engine oil), as otherwise reliable function of the Edging trimmer cannot be guaranteed. [. . . ] Cylinder bottom gasket defective, crankshaft seals damaged, cylinder or piston rings defective or improper sealing of spark plug Broken starter spring, broken parts inside of the engine Carburetor contaminated, must be cleaned Mechanical fault Warm start problems Several systems may simultaneously be affected Engine idling poor For handheld engine : The Emissions Compliance Period referred to on the Emissions Compliance label indicates the number of operating hours for which the engine has been shown to meet Federal emission requirements. Category C=50 hours, B=125 hours, and A=300 hours. , La Mirada, California, (herein "MAKITA") warrant to the initial retail purchaser and each subsequent owner, that this utility equipment engine (herein "engine" ) was designed, built, and equipped to conform at the time of initial sale to all applicable regulations of the U. Environmental Protection Agency (EPA), and that the engine is free of defects in materials and workmanship which would cause this engine to fail to conform with EPA regulations during its warranty period. [. . . ]