User manual DOMENA CX 30 ECOFIBRES DATASHEET

[. . . ] Unhook the fixing strap and ensure that it goes into the compartment below the iron rest (leaving the tab exposed). Remove the water reservoir from its housing by pulling it towards you. Pull out the electric cable as far as you need. Do not pull it out further than indicated by the coloured band on the cable. [. . . ] Never fill the reservoir with hot water. Refilling whilst ironing You can fill the reservoir during ironing. It is not necessary to switch off or unplug your ironing centre when refilling. ⷠRemove the anti-scale cartridge from the water tank and fill it. To obtain steam, the anti-scale cartridge must be inserted into the water tank. We recommend that you iron articles in the order indicated on the iron's thermostat dial so that the temperature gradually increases. To use steam please ensure that the thermostat dial is set within the 2 and 3 dot settings. Adjust the steam output to suit the type of material being ironed. The volume of steam increases gradually as you turn the control knob towards the maximum. ⷠAt maximum setting, there is an initial burst of steam lasting for several seconds. the steam output will then return to the normal rate. To repeat this process, wait for a few seconds to avoid any risk of spotting. Never call for steam when there is no water in the reservoir. please note · Because of the high steam output rate, there is no need to continuously press the steam button. Pressing the button briefly and frequently will enable you to control the quantity of steam, in order to obtain professional results. It also prolongs the life of your anti-scale cartridge. ⷠIf the iron is used intensively, steam may continue to be produced after the steam button has been released and water may appear on the iron holder. There is no risk of the metal being damaged. ⷠYou should turn the steam output dial to the middle setting when - the unit is used for the first time, - the water tank has been refilled, - the anti-scale cartridge has just been changed. It is recommended that you use the ECO function when the garments are only slightly creased, have come out of a tumble dryer and whenever you think suitable. In this way you will be obtaining maximum economy in the use of water and electricity, up to 50% in electricity and 70% in water. The illuminated pilot light will confirm that this mode is operational. [. . . ] You can store both the steam hose and hose support using the storage clip and store the appliance flat without having to empty the reservoir. ⷠIf you store the appliance on its side, water from the reservoir may spill out. The EMC system therefore eliminates any risk of scaling. Anti-scale cartridge change indicator light A) When the anti-scale cartridge begins losing its effectiveness, the EMC system is activated. [. . . ]