User manual DOMENA NVT 50

[. . . ] - Das Kabel von heißen Flächen fernhalten. - When unplugging the machine, pull the plug, not the cable. - Der Reiniger darf bei beschädigter Anschlußschnur, undichtem Wasserbehälter oder - Do not use the iron if it is damaged, if it leaks, or if the power cable is damaged. Nehmen Sie mit ihrem avoid any risk of electric shocks, do not dismantle your iron. [. . . ] TYPES OF WATER You can use : tap water, distilled water for irons, and water produced by a condenser tumble drier provided that it is filtered (e. Do not use : Rain water, water from the fridge, water from any evaporator appliance. Remove the strip, shake it briefly and wait for about one minute. Count the number of squares that have changed colour from green to mauve. - 17 C D CHANGING THE ANTI-SCALE CARTRIDGE The lifetime of your anti-scale cartridge depends upon the hardness of your tap water, and also how often you use your appliance. Based on the average use of 2 hours per week (i. 2 hours of steam) your cartridge will last: A. 1 square turned to mauve – this means a low level of scale – replace your cartridge after 24 months B. 2 squares turned to mauve – an average level of scale – replace your cartridge after 12 months C. 3 squares turned to mauve – high level of scale – change your cartridge after 6 months D. 4 squares turned to mauve – extremely hard water – change your cartridge every 3 months. € Insert the anti-scale cartridge into the empty tank. To obtain steam, the anti-scale cartridge must be inserted into the water tank. - 18 - FILLING THE WATER TANK • With the anti-scale cartridge in place fill up the tank with tap water. The tank is detachable : lift vertically to remove and place directly under tap for filling. € Push the anti-scale cartridge firmly down in the tank and replace the tank cap. reseat tank in cleaner , ensuring tank is fully home. Never fill the reservoir with hot water. Never add products containing alcohol or essences (perfume, eau de Cologne, lavender essence…) to the water. When switching on, the generator heating pilot light comes on. Wait about 3 minutes for the appliance to be ready, when the generator heating pilot light go off. Press the steam trigger on the steam gun. [. . . ] None of the lights are - Power supply problem - Other lit. The iron does not heat - Appliance not plugged in up. - The reservoir is empty - The reservoir is incorrectly inserted or has not been inserted. - The anti-scale cartridge has not been inserted - The anti-scale cartridge is incorrectly inserted in the reservoir - Other - Check the plugs and mains - Go to your local dealer - Plug in the appliance - Go to your local dealer - Press the steam button - Fill the reservoir - Insert the reservoir and replace the tank cap - Insert an anti-scale cartridge into the reservoir - Insert the anti-scale cartridge correctly and replace the tank cap - Go to your local approved service dealer - Fill the reservoir - Insert the reservoir and replace the tank cap - Go to your local approved service dealer - Wait until the indicator light illuminates again before requesting steam. [. . . ]