User manual DOMEOS DOS281SP

[. . . ] Thank you for purchasing one of our appliances. Please read these notes thoroughly as they have been written to help you obtain the maximum performance from the appliance. The quality of the appliance is guaranteed as each one of our products is fully tested as it comes off the production line. Use the appliance and you will see just how much satisfaction you will get. [. . . ] Fit the centre hinge 4 together with the underlying plastic plate from the other side to fix the door in position. After having rotated the hinge to the correct position 2, replace pin 1, then refit foot in the same hinge housing from where it was removed. Fix the lower hinge in position using the two screws. If the appliance is delivered with the vertical handle already fitted and the door opening direction needs to be changed, the handle itself must also be moved as follows: 2i Remove the handle by unscrewing the two fixing screws. 2l Remove the hole plugs on the opposite side of the door by pressing them lightly. 2m Rotate the handle 180° and fit it in place using the two fixing screws. If the appliance is supplied with a separate vertical handle, it can be fitted as follows: 2m Take the handle and screws supplied. 2m Position the handle over the holes and fix it in position using the screws supplied. When installing the appliance, remember the F After the appliance has been placed in its final position, leave it for about an hour before connecting it to the power supply. A Do not install it near to sources of heat such as heaters, radiators, cookers, G Make sure that the appliance is working properly before placing any food in it. H Leave a space of at least 5 cm between the top of the appliance and any B Position the appliance in a dry well-ventilated location. C Do not install the appliance in non-ventilated spaces such as wall nich- I Some appliances are fitted with rear wheels to enable them to be moved es. D Make sure that during the automatic defrost, any water on the back wall WARNING: DO NOT INSTALL THE APPLIANCE NEAR TO ANY HEAT of the compartment runs into the drain channel. SOURCES AND LEAVE A GAP OF AT LEAST 5 CM ABOVE IT E If the appliance is supplied with spacers, fit them to the upper part of the Check that the mains voltage complies with that indicated on the rating plate located on the bottom left of the freezer compartment. If the mains socket does not have an earth connection or if the plug is not suitable for the mains supply system, refer to a qualified electrician. Do not use adapters or extension leads, as these may overheat and burn. Rewirable 13 Amp (BS1363) plug is used, it must be fitted with a 15 Amp ASTA approved (BS1362) fuse. If any other type of plug is used it must be wired as follows. Connect the GREEN & YELLOW wire to the earth terminal marked with the letter "E" or earth symbol, or coloured green or green & yellow. Connect the BLUE wire to the neutral terminal marked with the letter "N" or coloured black. Warning: this appliance must be earthed Connect the BROWN coloured wire to the live terminal marked with the letter If the appliance has been fitted with a non-rewirable plug of the incorrect "L" or coloured red. Type for the mains socket, cut off the plug and fit a new one. [. . . ] NEVER place ice cubes in the mouth or eat ice-lollies that have just been taken out of the freezer, as these can cause ice burns. dO NOT place sealed containers containing liquids such as soft-drinks or similar in the freezer. Hot foods and drinks must be allowed to cool before being placed in the freezer. Make sure that the packaging is intact and that there are no damp marks or swelling, in that these indicate that the frozen product may already have deteriorated. [. . . ]