User manual DOMETIC 9000 PLUS INSTALLATION

[. . . ] They give the level of risk for potential injury. !WARNING indicates a potentially hazardous situation which, if not avoided, could result in death or serious injury. !CAUTION indicates a potentially hazardous situation which, if not avoided, may result in minor or moderate injury. used without the safety alert symbol indicates, a potentially hazardous situation which, if not avoided, may result in property damage. [. . . ] This will allow enough space between side wall and awning hardware to feed fabric into awning rail. 2 Door Edge Guard 4 8275000 & 8485000 Series Universal Plus Hardware Installation Instructions FIG. With one person grasping each support arm, carefully lift the entire assembly upright. Keep the two arm assemblies parallel to each other to avoid damage due to twisting. Carry the awning to the prepared awning rail end. Fabric Roller Tube Assembly Find a solid structure in the coach wall to anchor the #14 X 3" hex head screw. The relationship of the solid structure with the awning rail will determine the position of the top mounting brackets. The top mounting bracket can be placed over, on or under the awning rail as shown in FIG. If the top mounting bracket cannot touch the side of the coach because the awning rail is too wide, a stand off is available. This will allow the top bracket to clear the wider awning rail. Part number for the (one) stand off is 3109623. 003 and 50 count package 3109623. 550 Important: If top bracket must be mounted over top rail as shown in Figure 7B, care should be taken to note radius roof construction. If radius cap molding is rubber, there could be the possibility for water leaks if top bracket is fastened against the rubber molding. In those applications, it is recommended that the top leg of the bracket be fastened against the awning rail flange as shown in FIG. Note: Top rafter bracket assembly is independent of the main support arm assembly. Awning Rail Arm Assembly FIG. 7 Feed the awning into the awning rail while standing on a stepladder, (third person) while two carry the awning assembly to the desired position. After the complete awning assembly has been threaded into the awning rail, check to be sure that its position allows for solid mounting of the top and bottom brackets and that support arms are in desired location (not restricting use of doors, access doors, windows, etc. ). 6 Reinstall rafter assemblies into the hardware. 6 #14 x 3" Hex Head Screw Mount Top Bracket Over Awning Rail Awning Rail Top Pivot Rafter FIG. 7A Awning Rail With Drip Channel #14 x 3" Hex Head Screw Mount Top Bracket Below Awning Rail The top mounting bracket can be placed in several different positions in relationship with the awning rail. Some awning rails have a drip channel to catch water as it runs off the roof and drain it to the front or rear of the coach. Top Pivot Rafter 5 8275000 & 8485000 Series Universal Plus Hardware Installation Instructions FIG. 7B Awning Rail With Drip Channel #14 x 3" Hex Head Screw 7. Snap the patio foot on the bottom of the inner arm into the bottom bracket. [. . . ] Hole Closest To Main Arm 5/16" - 18 Bolt and Lock Washer Adjustable Arm STANDARD SIDE Inner Arm 5/16" - 18 x 1" Shoulder Bolt b. The model 8485000 hardware has the water dump feature. The stop is a slide attached to the main arm with a #6-20 x . 44" screw. It performs the same function as the stop bolt mentioned in "8a". [. . . ]