User manual DOMETIC ANALOG CONTROL KIT

[. . . ] Keeping windows and doors shut or minimizing usage 4. Avoiding the use of heat producing appliances Starting the air conditioner early in the morning and giving it a "head start" on the expected high outdoor ambient will greatly improve its ability to maintain the desired indoor temperature. RECOGNIzE SAFETY INFORMATION This is the safety-alert symbol. When you see this symbol in this manual, be alert to the potential for personal injury. Follow recommended precautions and safe operating instructions. For a more permanent solution to a high heat gain, accessories like A&E outdoor patio and window awnings will reduce heat gain by removing the direct exposure to the sun. [. . . ] High Speed: Selected when maximum cooling and dehumidification are required. Low Speed: Selected when RV reaches desired comfort level and needs to be maintained. Normally this speed is used for nighttime operation. Select Auto/On Switch operation as follows: (switch located at upper center of thermostat) a. Auto Position: Air conditioner fan runs whenever cooling is required and stops whenever cooling is not required. On Position: Air conditioner fan runs continuously to circulate air in RV. B. FURNACE OPERATION (If Furnace is connected to Thermostat) . Set the Temperature Set Lever to desired temperature level (located at right of thermostat). Set the System switch to furnace position (located at left side of thermostat). The furnace will now come on when heat is required and cycle off when temperature level selected is reached. 3. 4. Set the System Switch to cool position (located at left side of thermostat). The air conditioner compressor will now come on when cooling is required and cycle off when the temperature level selected is reached. C. System Switch: is in the OFF or FURNACE position and 2. Auto/On Switch: is in the ON position, the air conditioner fan will run continuously at selected fan speed to circulate the air inside the RV. OPTIONAL FEATURE: Electric Heat Strip (If Unit so Equipped) . Set the Temperature Set Lever (located at right of thermostat) to desired temperature level. Set the System Switch (located at left side of thermostat) to heat strip position. Wait at least two (2) minutes before restarting the air conditioner after shutting off with either the Heat/Off/Cooling Switch or the Temperature Set Lever. This allows the refrigerant pressure in the air conditioner to equalize and will allow the compressor to restart easily. Failure to follow this instruction may cause circuit breakers or fuses to open. 3 E. OPTIONAL FEATURE: Heat Pump (If Unit so Equipped) . Set the Temperature Set Lever (located at right of thermostat) to desired temperature level. Set the System Switch (located at left side of thermostat)toheatpumpposition. 4. [. . . ] If your RV is connected to motor generator, check to be sure motor generator is running and producing power. If RV is connected to power supply by a land line, check to be sure line is sized properly to run air conditioner load and it is plugged into power supply. Check your 5 VAC fuse or circuit breaker to see if it is open. After the above checks, call your local service center for further help. [. . . ]