User manual DOMETIC BRISK AIR AC INSTALLATION

[. . . ] INSTALLATION INSTRUCTIONS RECORD THIS UNIT INFORMATION FOR FUTURE REFERENCE: Model Number Serial Number Date Purchased BRISK AIR 579 Series, 590 Series, & 595 Series USA SERVICE OFFICE Dometic Corporation 2320 Industrial Parkway Elkhart, IN 4656 574-294-25 CANADA Dometic Corporation 46 Zatonski, Unit 3 Brantford, ON N3T 5L8 CANADA 59-720-9578 For Service Center Assistance Call: 800-544-488 ® ROOF TOP AIR CONDITIONER USED WITH 3107210 AIR DISTRIBUTION BOX KIT and 3109226. 005 COMFORT CONTROL CENTER ELECTRONIC KIT 3109228. 001 (White) Comfort Control CenterTM 3109228. 019 (Black) Comfort Control CenterTM This manual must be read and understood before installation, adjustment, service, or maintenance is performed. This unit must be installed by a qualified service technician. Modification of this product can be extremely hazardous and could result in personal injury or property damage. Lire et comprendre ce manuel avant de procéder à l'installation, à des réglages, de l'entretien ou des réparations. L'installation de cet appareil doit être effectuée par un réparateur qualifié. [. . . ] Try to avoid hard to reach and hard to see areas. Refer to the instructions provided with the Remove Temperature Sensor for details of installation. 6 INSTALLATION INSTRUCTIONS 3. A 3/8" diameter hole will be needed to route the cable through the wall. CONTROL CABLE INSTALLATION A 4-conductor control cable must be routed from the roof opening to the Comfort Control CenterTM. Choose the shortest, most direct route from the 4/4" (±/8") opening to the Comfort Control CenterTM location selected. Leave 6" of cable extending through the wall. Thecontrolcablethatshouldbeusedisaflat, 4- conductor telephone cable. The control cable must be terminated with two (2) RJ-4C-6P telephone connectors. Refer to the crimp tool manufacturer for crimping instructions. Important: RJ-11-4C-6P connectors must be installed as shown in FIg. PLACINg THE AIR CONDITIONER ON THE ROOF A. Remove the Air Conditioner from the carton and discard. 6 This unit weighs approximately 100 pounds. To prevent back injury, use a mechanical hoist to place Air Conditioner on roof. C. Lift and place the unit over the prepared opening using the gasket on unit as a guide. The exposed coil goes toward the rear of the RV. C. Carefully remove the base plate from the Comfort Control CenterTM. This may be accomplished by inserting a small screwdriver under the tab on the bottom edge of the front cover and gently prying. This may damage the neoprene gasket attached to the bottom and create a leaky installation. D. Place the Air Box Kit and Electronic Control Kit inside the RV. Both kits contain mounting hardware for the air conditioner and will be used inside the RV. Insert the control cable through the hole in the base plate and mount the plate to the wall with the two screws provided. [. . . ] Tighten strain relief, making sure enough wire is inside electronic box to connect with unit 20 VAC wire. Tighten screws on strain relief connector being careful not to pinch and cut into the insulation on power supply leads. Connect the white to white; black to black; and green to green or bare copper wire using approprimately sized twist wire connectors. Tape the twist wire connectors to the supply wiring to assure they do not vibrate off. [. . . ]