User manual DOMETIC DS 600 REV 2004-06-24

[. . . ] DS 200 miniCool DS 300 DS 400 DS 600 Freestanding and Built-in under version Frei stehende Version und Einbauversion. Version pose libre et version encastrable. Versão isolada e Versão incorporada. Vapaasti seisova malli ja upotettava malli. [. . . ] Do not wash any plastic parts in water that is more than hand warm, and do not expose them to dry heat. The outside of the cabinet should be wiped down regularly with a clean, damp cloth. NEVER USE STRONG CHEMICALS OR ABRASIVE CLEANING MATERIALS ON ANY PART OF THE CABINET. the rear cover) into the surrounding air. The more ventilated the condenser is, the more effective the refrigeration will be. The other condition for satisfactory operation is that the appliance stands on a flat surface. This is best seen by placing a glass of water on top of the appliance. It is important that the appliance is not directly exposed to radiated heat (sunlight, radiator, near an oven, etc. ). Please do not place the refrigerator onto thick carpet! 4. Built-in version When first using this refrigerator please consider the following points: ENSURE REFRIGERATOR IS LEVEL THE PIPEWORK AT THE BACK GETS HOT IN USE THE REFRIGERATOR HAS NO 'MOTOR' AND IS THEREFORE VIRTUALLY SILENT ALLOW AT LEAST 3 HRS. FOR SIGNS OF COOLING During the refrigeration process, the appliance gives off heat from the condenser (under the upper part of All four sizes of the miniCool family are available in builtin and freestanding version. This version is planned for building-in under purposes. Built-in under model does not have foot frame, cooling unit room cover, compared to the freestanding version. The miniCool can be screwed to the furniture using the fittings at the bottom. Drive in the screws (figure 3). 5 GB C Air out D miniCool min. 60 mm Ventilation grille Air out miniCool Air in Air in Figure 3. 4. 1. 2. Freestanding version This version is supposed to use freestanding. Cooling unit room cover protects from the hot parts of the cooling unit. Foot frame with grilles ensures sufficient ventilation. During installation, please ensure the mains plug is accessible at all times. Figure 5. 5. Using the appliance IMPORTANT Please follow the installation details below carefully Guarantee is valid for products installed as described only. The refrigerator must be level both directions 2. There should be 20mm clearance to the wall 3. Ventilation must be provided as shown in alternatives A, B, C or D (fig 4-5) 4. [. . . ] 11) Figure 10. If the refrigerator is furnished with handle, it is the handle that should be first removed at the change of the door panel. 1 3 1 2 Disconnect at the mains. Loosen up 6 screws (1) of footframe and remove the footframe. Put the fridge on a desk to ease the work. Open the door and snap out the fixing tab (2) of the upper hinge pin by the help of screwdriver and push out the pin. [. . . ]