User manual DOMETIC EA3255

[. . . ] Connecting to the mains The refrigerator must only be connected to the electricity supply using an earthed socket outlet, installed in accordance with local regulations. Before connecting the refrigerator, check from the data label inside the cabinet that the voltage agrees with your mains supply. Plug connection (for United Kingdom only). If a 3-pin 13 amp fused plug is used, it should be fitted with a 3 amp fuse; with other plug types, the circuit should contain a 5 amp fuse. [. . . ] Allow hot food and drink to cool down before placing them in the refrigerator. The temperature in the freezer section of the unit is set at -12° C. Frozen products can be stored here for short periods (please follow the instructions on the packet very carefully!). Do not keep any easily combustible substances such as ether, petrol, adhesive, propane gas etc in the refrigerator, it could explode! SWITCHING ON Inside the refrigerator you will find a plastic bag containing 4 small wheels. Carefully place the refrigerator on its back and insert the pins of the wheels into the metal holders located on the underside of the refrigerator. In this way you can always move your refrigerator to where it is needed. To switch on the refrigerator, plug it into the socket and turn the thermostat (in the inside compartment) to position 2 or 3. The appliance will be cool in about one hour. The temperature inside the refrigerator is affected by location, room temperature and too frequent opening of the door. Adjustment of the thermostat dial may therefore be necessary. Temperature control The cooling capacity can be adjusted by means of the termostat. 0 = cooling is switched off, from 1-5 the temperature decreases. When the termostat is at a medium setting (2 or 3) and the ambient temperature is normal, the temperature inside the refrigerator is between 0°-7° C. Depending on the ambient temperature, service life, and quantity and temperature of the refrigerated items, the temperature inside the refrigerator can ICE CUBES Fill the ice cube container to 4/5 with potable water. Place the ice cube container in the freezer section. Wipe off any excess water to prevent the ice tray from freezing to the surface. To speed up the making of ice cubes, turn the thermostat to position 5 for a short while. Remember to turn the dial to its normal setting when the ice cubes are frozen. 13 GB To remove the cubes from the ice tray, hold it under running water. Remove the lid with the ice cubes from the ice tray and the ice cubes can now be taken out easily. Leave the door open to prevent unpleasant odours from forming. Changing the lightbulb If the lightbulb needs changing, pull out the plug and proceed as follows: Push the sheet reflector up and pull the lamp cover away backwards. Replace the bulb and push the covering back into place. [. . . ] State the problem, model and product number. (Details of the model and product number are to be found on the data label in the top left of the inside compartment. ) 14 GB IMPORTANT ADVICE Do - make sure that drinks and food, particularly those with a strong smell, are closed tightly or well packed; - close the door properly after use. The door should only be left open a little when the refrigerator is switched off; Do not - use sharp objects to remove the frost layer or free the ice tray; - obstruct the airflow on or above the cooling unit; - put any hot or warm food/drinks into the refrigerator - allow them to cool down first Electrical data Connecting Power, 230 V . . . . . . . . . . . . . . . . . . . 115 W Energy used in 24 hours . . . . . . . . . . . . . . . . . . . . [. . . ]