User manual DOMETIC GENESIS INSTALLATION

[. . . ] 3308120. XXX GENESIS AIR FILTRATION SYSTEM 3308120. XXX GENESIS AIR FILTRATION SYSTEM USA SERVICE OFFICE Dometic Corp. LaGrange, IN 46761 260-463-4858 CANADA Dometic Dist. Cambridge, Ontario CANADA N3H 2N7 519-653-4390 For Service Center Assistance Call: 800-544-4881 FOR 57XXX SERIES 59XXX SERIES 600XXX SERIES 620XXX SERIES 630XXX SERIES AIR CONDITIONERS & HEAT PUMPS USED WITH 3109226. 005 ELECTRONIC CONTROL KIT 3109407. 001 ELECTRONIC CONTROL KIT 3107541. 009 ANALOG CONTROL KIT 3107541. 017 ANALOG CONTROL KIT 3107546. 008 ANALOG CONTROL KIT INSTALLATION AND OPERATING INSTRUCTIONS REVISION Form No. 3308129. 026 5/03 (Replaces 3308129. 018) (French 3308134. 026) ©2003 Dometic Corporation LaGrange, IN 46761 MODEL 3308120. XXX GENESIS AIR FILTRATION SYSTEM Important: These instructions must stay with unit. [. . . ] AIR DISTRIBUTION SYSTEM INSTALLATION Dometic Corporation recommends the basic configuration shown in FIG. 1 for installing this air conditioner/heat pump system. We have found by testing, that this configuration works best in most applications of this air conditioner/heat pump system. It is the responsibility of the Installer of this system to review each RV floor plan and determine the following: A. These items must be determined in conjunction with the Air Distribution System Sizing and Design Requirements listed in Section 3 of this manual. Important: Alternate configurations and methods may be used which still allow the air conditioner/heat pump to operate properly. However, these alternate configurations and methods must be approved by Dometic Corporation in writing. The following instructions are based upon the use of Dometic Genesis Air Filtration System No. Before preparing the ceiling opening, the type of system options must be decided upon. Read all of the instructions packaged with the system options before beginning the installation. CAUTION It is the responsibility of the installer to insure the ductwork will not collapse or bend during and after the installation. Dometic Corporation will not be liable for roof structural or ceiling damage due to improperly insulated, sealed or collapsed ductwork. H. Return Air to the air conditioner/heat pump must be filtered to prevent dirt accumulation on air conditioner/ heat pump cooling surface. Total System Static Air Pressure This is to be determined with the air conditioner/heat pump blower operating on High Speed and return air filter and grill in place. It is measured in inches of water Column. A 14-1/4" x 14-1/4" (±1/8") opening must be cut through the roof and ceiling of the RV. This opening must be located between the roof and reinforcing members. !WARNING There may be electrical wiring between the roof and the ceiling. Disconnect 115 volt AC power cord and the positive (+) 12 volt DC terminal at the supply battery. Failure to follow this instruction may create a shock hazard causing death or severe personal injury. 2. Mark a 14-1/4" x 14-1/4" (±1/8") square on the roof and carefully cut the opening. Using the roof opening as a guide, cut the matching hole in the ceiling. The opening created must be framed and sealed to provide adequate support and prevent air from being drawn from the roof cavity. Lumber 3/4" or more in thicknessmust be used. [. . . ] To reset the "CLEAN FILTER" reminder: a. Depress the gray button "FILTER RESET" on the decal of the grill. The Light will blink 3 times to indicate a successful reset. Install the slider in the return air cover and raise it to the ceiling template. [. . . ]