User manual DOMETIC MSP164

[. . . ] do not operate the device in a damp or wet environment. Maintenance and repair work may only be carried out by qualified personnel who are familiar with the risks involved and the relevant regulations. The device must be set up and fastened in such a way that it cannot tip over or fall down. Take the precautions necessary to ensure that children cannot interfere with operation. [. . . ] The inverter must be installed in a place that is protected from moisture. A ventilation system must be present for installations in small, closed spaces. The minimum clearance around the inverter must be at least 25 cm (fig. The air intake on the underside or the air outlet on the back side of the inverter must remain clear. For ambient temperatures higher than 40 °C (such as in engine or heating compartments, or direct sunlight), the heat from the inverter under load can lead to the automatic shut-off of the inverter. The installation surface must be level and sufficiently strong. Caution Before drilling any holes, ensure that no electrical cables or other parts of the vehicle can be damaged by drilling, sawing and filing. 3, page 4): Clip two holders on the lower left bar and two on the right. The middle pin of the plug must be connected to the positive wire (fig. 1 6, page 3) and the two side brackets of the plug must be connected to the negative wire (fig. If the connection is loose, the plug may heat up. Caution The rating of the socket, the supply cable and the fuse must be at least 15 amps. Do not put in a fuse with a higher rating. Warning Never use the inverter on vehicles where the positive terminal of the battery is connected to the chassis. When installed in vehicles or boats, the inverter must be connected to the chassis or earth. Fit a 50 A cable fuse as close to the battery as possible on the positive cable. Caution If you do not fit a fuse in the positive cable, it could damage the inverter and invalidate the guarantee. Make sure the battery poles are clean when connecting the terminals. Caution Only extend the connection line with cables with a cross section that is equal to or greater than that of the connection line. These fuses should only be replaced by a qualified electrician. Note Connect the external switch to the inverter using a connection cable with Western telephone jack. Cut the connection cable to size according to the wiring diagrams or have the device connected up by a specialist. [. . . ] Red, constant light Short circuit or electrical wiring error Excessive load Check electrical wiring. If the product is defective, please return it to the WAECO branch in your country (see the back of the instruction manual for the address) or to your dealer. For repair and guarantee processing, please include the following documents when you send in the appliance: A copy of the receipt with purchasing date A reason for the claim or description of the fault If you wish to finally dispose of the device, ask your local recycling centre or specialist dealer for details about how to do this in accordance with the applicable disposal regulations. Item number Rated input voltage Constant output power Peak output power Output voltage Output frequency Idle current consumption Input voltage range Low voltage alarm/shutdown Ambient temperature Heat dissipation Dimensions (mm) Weight Testing/certification Technical data MSP 352 Item number Rated input voltage Constant output power Peak output power Output voltage Output frequency Idle current consumption Input voltage range Low voltage cut-off Ambient temperature Heat dissipation Dimensions (mm) Weight (kg) Testing/certification 1. [. . . ]