User manual DOMETIC PENGUIN HP INSTALLATION

[. . . ] RECORD THIS UNIT INFORMATION FOR FUTURE REFERENCE: Model Number Serial Number Date Purchased USA SERVICE OFFICE Dometic Corporation 2320 Industrial Parkway Elkhart, IN 46516 574-294-2511 CANADA Dometic Corporation 46 Zatonski, Unit 3 Brantford, ON N3T 5L8 CANADA 519-720-9578 For Service Center Assistance Call: 800-544-4881 MODEL 630025. 331 Roof-Top Heat Pump used with 3106152. 006 Mechanical Air Distribution Box C US This manual must be read and understood before installation, adjustment, service, or maintenance is performed. This unit must be installed by a qualified service technician. Modification of this product can be extremely hazardous and could result in personal injury or property damage. Lire et comprendre ce manuel avant de procéder à l'installation, à des réglages, de l'entretien ou des réparations. L'installation de cet appareil doit être effectuée par un réparateur qualifié. [. . . ] The opening created must be framed to provide adequate support and prevent air from being drawn from the roof cavity. Lumber 3/4" or more in thickness must be used. Remember to provide an entrance hole for power supply. 6 Do Not Cut Roof Structure Or Rafters 3/4" Min. There may be electrical wiring between the roof and the ceiling. Disconnect 120 volt AC power cord and the positive (+) 12 volt DC terminal at the supply battery. Failure to follow this instruction may create a shock hazard causing death or severe personal injury. The 14-1/4" x 14-1/4" (±1/8") opening is part of the return air system of the Air Conditioner and must be finished in accordance with NFPA Standard 501C Section 2. 7. 2. Remove all caulking compound around opening. Seal all screw holes and seams where the roof gasket is located. Use a good grade of all weather sealant. 5. Good-Rafters Good LocationSupported By Between Roof Cross Beams Rafters Frame Opening So It Won't Collapse When Bolting Down Unit Leave Access For Power Supply Wiring 15" Min. At Front Of Opening CAUTION It is the responsibility of the installer of this air conditioner system to ensure structural integrity of the RV roof. Never create a low spot on the roof where water will collect. Water standing around the air conditioner may leak into the interior causing damage to the product and the RV. 5 630025. 331 Installation Instructions D. 1. Wiring Requirements 120 VAC Supply Line Route a copper 12 AWG, with ground, 120 VAC supply line from the time delay fuse or circuit breaker box to the roof opening. This supply line must be located in the front portion of the 14-1/4" x 14-1/4" (±1/8") opening. The power MUST be on a separate 20 Amp time delay fuse or HACR circuit breaker. Make sure that at least 15" of supply wire extends into the roof opening. This ensures and easy connection at the junction box. Wiring must comply with all National, State and Local Wiring Codes. Use a steel sleeve and a grommet or equivalent methods to protect the wire where it passes into the opening. 4. Place the 3106152. 006 Mechanical Air Distribution Box Kit. This box contains mounting hardware for the air conditioner and will be used inside the RV. Minor adjustments can be done from the inside of the RV if required. F. [. . . ] Periodically remove the return air filter located above the removable panel in the air box. Wash the filter with soap and warm water, let dry and the reinstall. Note: Never run the air conditioner without return air filter in place. This may plug the unit evaporator coil with dirt and may substantially affect the performance of the unit. [. . . ]