User manual DOMETIC PP2002

[. . . ] Persons whose physical sensory or mental capacities prevent them from using this device safely should not operate it without the supervision of a responsible adult. Always keep and use the device well out of the reach of children. Installing the device may only be performed by qualified personnel who are familiar with the guidelines and safety precautions to be applied. If electrical devices are incorrectly installed on boats, corrosion damage might occur. [. . . ] You can fasten the inverter using the holders supplied. Note the following safety instructions during installation: Set up the device securely and fasten it in such a way that ­ it cannot tip over or fall down ­ it cannot move while the vehicle is in motion Take precautions necessary to ensure that it is out of reach of children. Dangerous situations may occur which cannot be recognised by children! When selecting the installation location, observe the following instructions: Do not operate the device ­ in wet or damp environments ­ in dusty environments ­ in the vicinity of flammable materials ­ in spaces where there is a danger of explosion Do not expose the device to a heat source (such as direct sunlight or heating). avoid additional heating of the device in this way. Make sure the cables are the correct length and choose the installation location near the battery supply. select a well-ventilated location for the device. A ventilation system must be present for installations in small, enclosed spaces. Make sure that the air intake on the front of the inverter remains clear. Caution Before drilling any holes, make sure that no electrical cables or other parts of the vehicle can be damaged by drilling, sawing and filing. Clip two holders on the left bar and two on the lower right bar. The following information is intended for specialists who are familiar with the guidelines and safety precautions to be applied. Observe the following safety instructions for the electrical connections: Caution ­ Risk of short circuit!When working on the vehicle, always disconnect the earth connection to the supply battery. disconnect the 230 V external power supply to the caravan. If you have to feed cables through metal walls or other walls with sharp edges, use ducts or tubes to prevent damage. Do not lay cables which are loose or bent next to electrically conductive material (metal). Lay the cables so that they cannot be tripped over or damaged. If you wish to connect more than one consumer to the inverter and install a socket distributor loop, you must arrange a circuit breaker (residual current circuit breaker) and set a grounding bridge in the inverter, see chapter "Connecting multiple consumers" on page 35. 2 4, page 3) with the earth of the vehicle. Note Please be aware that all volatile memories of the connected electric consumers will lose their stored data if the battery is disconnected. caution Make sure the polarity is correct. [. . . ] Input voltage too high Check the input voltage on the inverter and compare with the technical data for the inverter. Compare consumer power with the maximum power from the inverter. Defective fuse (in the inverter or the vehicle) Defective device The device switches on and off repeatedly The inverter switches off when the consumers are switched on Excessive constant load Starting current too high The output voltage is too low Battery voltage is lower than shutdown value (see "Low voltage shutdown" in chapter "Technical data" on page 41) Note The output voltage can only be measured correctly with a TrueRMS measuring device. If the product is defective, please contact the manufacturer's branch in your country (see the back of the instruction manual for the addresses) or your retailer. [. . . ]