User manual DOMETIC PP404

[. . . ] If you connect more than one device, a short circuit may occur. The device must be set up and fastened in such a way that it cannot tip over or fall down. Take the precautions necessary to ensure that children cannot interfere with operation. Dangerous situations may occur which cannot be recognised by children! [. . . ] The inverter is equipped with protection against thermal and electrical overloading, as well as excess and insufficient voltage. The inverter switches off: If its internal temperature is too high If the load exceed the values stated above If the input voltage is too high or too low The inverter can be switched on and off using the switch directly on the device or using an external switch. Note Note when connecting devices with an electrical drive (such as power drills and refrigerators), that they often need more power than is stated on the type plate. You can fasten the inverter using the four holders supplied. When selecting the installation location, observe the following instructions: The inverter can be mounted horizontally or vertically. The inverter must be installed in a place that is protected from moisture. A ventilation system must be present for installations in small, enclosed spaces. The clearance around the inverter must be at least 25 cm (fig. The air intake on the underside or the air outlet on the back of the inverter must remain clear. For ambient temperatures higher than 40 °C (such as in engine or heating compartments, or direct sunlight), the heat from the inverter under load can lead to the automatic shut-off of the inverter. The installation surface must be level and sufficiently sturdy. Before drilling any holes, ensure that no electrical cables or other parts of the vehicle can be damaged by drilling, sawing and filing. Clip two holders on the lower left bar and two on the right. 1 4, page 3) must be connected to the positive wire and the two side brackets of the plug (fig. If the connection is loose, the plug may heat up. Caution The rating of the socket, the supply cable and the fuse must be at least 15 amps. Do not put in a fuse with a higher rating. Make sure the battery poles are clean when connecting the terminals. Caution Only extend the connection line with cables with an equal or greater cross section. 2 1, page 4) on the back of the device has three positions: Switching on with an external device You can also switch the inverter on and off with an external switch. [. . . ] Let the inverter cool down and ensure better ventilation. Compare the device power with the maximum power of the inverter. No output voltage No output voltage The device switches on and off repeatedly The inverter switches off when the consumer is switched on The output voltage is too low. Defective fuse (in the inverter or the vehicle) Device defective Excessive constant load Starting current too high If the product is defective, please return it to the WAECO location in your country (see the back of the instruction manual for the address) or to your dealer. [. . . ]