User manual DOMETIC RM4211

[. . . ] 2 The roof mounted flue must be positioned vertically with a maximum inclination of 15°. drill a 60mm hole in the roof of the vehicle in proximity of the oven. To avoid damaging or denting the roof when installing the flue and to ensure sealing if required mount a 1mm thickness metal plate to the wall with the hole. [. . . ] To guarantee the roof is sealed and does not leak, after the oven has been on for several hours re-tightened the flue fixture nut. Feed the ducting into the flue until it stops and secure in place with a self-tapping screw. This appliance is designed for running off the following types of gas at the corresponding operating pressures. The gas supply pipe connected to the appliance must be a rigid metal pipe with sealed fittings. It is possible to fit a flexible hose, however, in this case the following conditions must be respected: A) The hose can be accessed easily for inspection; b) The hose must be protected against coming into contact with parts which heat up (for example parts underneath the burners); c) The hose must be protected against being damaged (twisting, pulling, trapping, . ); d) The hose must be protected against being trapped by moving parts (e. 5 m; f) The hose must be replaced before its expiry date; Once the appliance has been connected to the gas supply check for gas leaks utilising a non-corrosive fluid. This chapter refers only to models with the wording 12 V appliance. The following symbols identify which knob corresponds to which burner. Butane (G30): flame with yellow tips when ignited which becomes more intense in colour as the burner heats. Insert the drip tray with the spit already installed as illustrated in FIG. Press the purpose button to turn on rotating plate motor. The appliance runs off standard gas bottles which can be found in the country of use. The type of gas to use is clearly marked on the packaging and on the specifications label affixed to the rear of the appliance. However always respect the following instructions: gas bottles must always be located and positioned in the compartment provided for this purpose. They must always be vertical and fitted with a pressure regulator and easily accessible and not obstructed. Do not obstruct or impede access to the gas bottle to permit quick and easy access when replacing. : When replacing the gas bottle always take the following precautions: a) close all gas knobs; b) make sure there are no flames or fires in proximity of the gas bottle; c) close the gas valve on the bottle to be replaced; d) unscrew the pressure regulator on the empty bottle and remove the bottle from the purpose compartment. [. . . ] : When replacing the gas bottle always take the following precautions: a) close all gas knobs; b) make sure there are no flames or fires in proximity of the gas bottle; c) close the gas valve on the bottle to be replaced; d) unscrew the pressure regulator on the empty bottle and remove the bottle from the purpose compartment. This procedure is inverted for fitting a new bottle. If there are problems, call in an authorised gas service engineer. [. . . ]