User manual DOMETIC VHT 5200 V11-10

[. . . ] EN DE FR ES NL IT FI SV DA NO Vacuum Holding Tank System Instruction manual vierstufige Füllstandsanzeige Einbauanleitung . 13 Système de surveillance de réservoir Mode d'emploi . 19 Sistema de control del depósito Manual de instrucciones . 26 Tankmonitorsysteem Gebruiksaanwijzing . [. . . ] If any part of the hose system must be run close to a heat source, use rigid pipe instead of hose . 6. 4 Make connections 1 . Route 1 . 5 in . /38 mm ID sanitation hose from toilet to VHT inlet, and from VHT outlet to the boat's discharge fitting(s) (see previous section for hose routing guidelines) . VHT inlet and outlet fittings swivel to allow connection from virtually any direction (fig . Route 5/8 in . /16 mm vent hose from vacuum pump discharge to vent filter or thru-hull vent fitting . Place two hose clamps on hose near each end that attaches to fittings . 4) or liquid dishwashing soap on fitting and inside ends of hose, then twist hose onto fitting . Make sure hose end is flush against fitting shoulder . Tighten hose clamps at ends of sanitation hose with screws positioned as shown (fig . Vent hose requires only one hose clamp at each connection . 8 SailVac Vacuum Holding Tank Installation 5 . With electrical power off, make electrical connections according to the wiring schematic shown on the parts list provided with this unit . Electrical installation must follow ABYC standards and should be performed by qualified personnel only . Failure to follow the procedures above may result in vacuum leaks or inefficient flushing . If the toilet, holding tank or any components are connected to any through-hull fittings, properly installed seacocks must be installed in all piping connected to the through-hull fittings . Seacocks must be easily accessible to all users of the system . All valves must be full-bore valves and of marine (corrosion resistant) quality . Screw-to-close gate valves are not recommended . Failure to do so can result in flooding, which can cause the loss of life and property . Some marine practices and/or standards require the installation of a properly positioned ventilated (vented) loop in the discharge piping to prevent back-siphonage of seawater into the holding tank . Boat operator must know local sewage discharge regulations . 8 8. 1 Cleaning and winterizing Cleaning A small amount of water remains in vacuum holding tank at all times, so it is good practice to rinse the VHT completely after contents have been discharged . After initial pump-out, add holding tank deodorant or cleaner to toilet bowl, and flush with water . Continue flushing and pumping out tank until holding tank discharge is clear . 8. 2 Winterizing Use only propylene glycol freshwater antifreeze to winterize the holding tank . Make sure the antifreeze does not contain alcohol. [. . . ] If this Dometic product is placed in commercial or business use, it will be warranted to the original purchaser only to be free of defects in material and workmanship for a period of ninety (90) days from the date of purchase . Dometic reserves the right to replace or repair any part of this product that proves, upon inspection by Dometic, to be defective in material or workmanship . All labor and transportation costs or charges incidental to warranty service are to be borne by the purchaser-user . EXCLUSIONS IN NO EVENT SHALL DOMETIC BE LIABLE FOR INCIDENTAL OR CONSEQUENTIAL DAMAGES, FOR DAMAGES RESULTING FROM IMPROPER INSTALLATION, OR FOR DAMAGES CAUSED BY NEGLECT, ABUSE, ALTERATION OR USE OF UNAUTHORIZED COMPONENTS . [. . . ]