User manual DOMETIC WEATHERPRO

[. . . ] They give the level of risk for potential injury. Important: When installed correctly on a motorized RV, this system is wired to prevent accidental awning "extension" when vehicle ignition key is in the "ON" position. When the ignition key is turned "ON", the "extension" mode is de-activated and awning will not extend. This however, will not prevent the awning from being retracted. The A & E WeatherPro awning is equipped with a wind sensing device that will automatically close the awning when wind conditions are present that may damage the awning. [. . . ] If wind sensor is de-activated and damage to awning occurs, the awning warranty may be void. The wind sensor is specifically designed to allow air to pass across sensor probe. Important: The wind sensor will only function correctly if the airway to the sensing probe is clear. Keep airway clear of dust, insects, ice, snow, or other debris. The sensing probe can be cleaned with a mild soap solution and a small soft bristle brush. There are six (6) LED's in the WeatherPro control and one button for selecting the wind speed. Constant Yellow indicates there is 12 VDC power at the control. Flashing Yellow at the rate of 1 time per second, indicates voltage is below 10 (± . 50) VDC. Flashing Yellow at the rate of 3 times per second, indicates a fault has been detected in the wind sensor or the wind sensor cable. The LED that is yellow indicates the wind speed currently selected. Wind speed is preset from the factory at 18 MPH. The wind speed can be adjusted by pressing the wind speed selection button. To increase or decrease the sensor sensitivity, press and release the wind speed selection button until the desired wind speed LED is lit. Note: Awning is not intended for cold weather operation. Awning will automatically close when outside temperature reaches 32° F. when the wind sensor is activated. WeatherPro Control Box A. 12 VDC Power Indicator Wind Speed Setting Wind Speed Selection Button B C 24 21 18 15 12 Pinch Point Pinch Point To Close Awning: 1. Press and hold the "Retract" button for 3 seconds and the awning will automatically close. If not held for three seconds the awning will remain in the position when button is released and continue to close when pressed again. Press and hold the "Retract" button for 3 seconds and the awning will automatically close. If not held for three seconds the awning will remain in the position when button is released and continue to close when pressed again. EXTEND PATIO RETRACT EXTEND DOOR RETRACT EXTEND RETRACT Important: As an extra safety precaution, visually verify that the awning is fully closed. In Case Of Coach Power Failure LIMIT SWITCH PATIO SWITCH WIND SENSOR U. S. A. When the WeatherPro hardware is in the open position and the 12 VDC power has been lost the awning can be closed by using the auxiliary power cable provided with the hardware. Connect the awning motor to an external 12 VDC power source. [. . . ] The awning can be extended by reversing the polarity. Place the red wire on the ­ and the black wire on the +. Again, remove wires immediately after awning is fully extended. To Manually Close Awning: Important: This procedure will require two people. When this procedure has been performed, the awning must be serviced by a Dometic Service Center or a qualified service technician before using again. Slide the pull strap (provided) into the utility slot of the FRTA. [. . . ]