User manual DOMO DO486BL

[. . . ] During this period the manufacturer is responsible for any failures that are the direct result of construction failure. When these failures occur the appliance will be repaired or replaced if necessary. The warranty will not be valid when the damage to the appliance is caused by wrong use, not following the instructions or repairs executed by a third party. The guarantee is issued with the original till receipt. [. . . ] €¢ Pull the plug from the socket as soon as you’ve stopped using, disassembled or cleaned the device. Measuring cup (90ml) Lid Jar Motor unit Control knob Anti-skid feet 1 2 3 4 5 CONTROL KNOB 1. 6 Automatic programme for smoothies Automatic programme for vegetables Automatic programme for soup OFF: ‘off’-position PULSE – ON/OFF: Pulse function with on/off button Indication light: device in stand by = red, device working = blue Power indication light Speed setting control 39 o nl ow D DO486BL ad 4 ed fro m w w w 3 2 1 8 5 6 7 an . Put the plug into the socket and place the jar onto the device. Attention: The amount of ingredients may not exceed the maximum level indication on the jar!Make sure the jar is secury placed onto the jar. Place the measuring cup into the lid by matching the two small tabs on the measuring cup with the two notches in the lid’s fill opening. Lock the measuring cup in its place by turning it clockwise. Attention: always make sure the measuring cup is locked in its place before blending warm fluids. Attention: never use the blender without the lid on the jar. Select the speed, programme or use the pulse function by using the instructions below. Turn off the device after using it, turn the control knob in its OFF position and carefully pull the plug from the socket. STAND BY AND POWER SAVE MODE • • Put the plug into the socket and place the jar onto the device. The power indication light will turn on and the indication light around the PULSE - ON/OFF button will light up red. When the device hasn’t been used for 3 minutes, only the power indication light will remain lit up. Push the ON/OFF button to take the device out of the power save mode. Be DO486BL ad ed ON/OFF BUTTON • • • • This button is the on/off button for the various programmes To start a certain programme, select the programme you want by turning the control knob to the programme you prefer. The indication light surrounding the PULSE - ON/OFF button will now light up blue. Press the ON/OFF button once to stop the programme at any time. B e PULSE BUTTON • • This is the button to manually operate the pulse function. This button may be used to blend at full power for a short duration. To use the pulse function, the blender needs to be in stand by mode and the speed setting control needs to be in OFF. [. . . ] When you would like to stop the chosen programme, press the ON/OFF button again. After the programme has stopped, the blender will automatically return to stand by mode. CLEANING & MAINTENANCE • • • • • Carefully remove the plug from the socket. Never immerse the motor base, motor unit or the power supply cord in water or any other liquid. [. . . ]