User manual DRAKE DIGITAL SCTECI

[. . . ] SCTeci Ethernet Control Interface Instruction Manual TM is a trademark of the R. L. Drake Company is a registered trademark of the R. L. Drake Company © Copyright 2008 R. L. Drake Company P/N: 3852392B-01-2008 Printed in U. S. A. 2 Caution Statements WARNING: TO PREVENT FIRE OR ELECTRICAL SHOCK DO NOT EXPOSE TO RAIN OR MOISTURE A product and cart combination should be moved with care. [. . . ] This will produce a screen similar to below. Type desired password here. 1) Pressing the down arrow for a selected parameter will produce a drop down menu which will give the available choices. 2) Left click on the desired choice to select it. 3) On items which have no down arrow, the desired parameters can be typed in directly. If an illegal entry is typed in, an error message will be displayed. 4) Once you have changed all the parameters to your satisfaction, press the 'APPLY' button. This will perform the actual transcoder parameter changes. The top cell of the 'Status' table on the upper right corner of the display will show one of the following error messages: Search; Out of Lock; Out of range; QAM Version; Demod error; or if there are no errors, signal to noise ratio (SNR). The bottom cell displays the transcoder baud rate. The selection box in the upper left hand corner of this window allows selection of the displayed parameters for any other transcoder attached through PS15x power supplies. The 'Block of 10' button will produce a table which will show all 10 transcoders in the group containing the transcoder displayed in the box. 2) Type the desired SCT transcoder password into the box as shown in the above illustration. If the password is already programmed into the SCT, stop here. 3) If the password in the SCTs needs entered or changed, someone at the SCT transcoder location must simultaneously hold down the left, center, and right buttons on each SCT860 or PS151 for at least two seconds. This will cause 'LOADING PASSWORD' to appear on the SCT transcoder's display. Do this on each transcoder or power supply that needs the new password loaded. If being remote controlled solely with the SCTeci, a password of 0 should be entered. This will load the new password into the transcoder. 'LOADING PASSWORD' will disappear from the SCT transcoder's display and the new password will be loaded. PRESET CHANNELS The preset channels function allows you to add to, modify, or delete the selections that are available in the Demod Mode selection window which appears when programming individual SCTxxxx transcoders. To access this function, select 'Preset Channels' from the Select Mode drop down menu. You will be presented with a screen similar to the following: Note that the exact appearance of the screens shown here will vary depending upon the web browser used, and to the PC display resolution selected. In the above window, Internet Explorer V6 was used with a screen resolution of 800 x 600 pixels. Notice the 'Group' window on the left and the 'Add New Channel', 'Edit Channel', and 'Delete Channel' buttons at the bottom of the channels window. 10 Operation (continued) Deleting a Channel 1) From the Preset Channels screen, select the group and channel that you wish to delete. 2) Press the 'Delete Channel' button. [. . . ] DRAKE will make note of any shipping damage upon receipt. You will need to send proof of purchase to receive warranty service. Typically, a copy of the invoice from an R. L. The warranty is for the original owner only and is not transferable. 14 Warranty Three Year Limited Warranty R. L. [. . . ]