User manual DRAKE DIGITAL SRR60

[. . . ] SRR60 Sound Reinforcement Receiver Users' Manual TM is a registered trademark of R. L. Drake LLC P/N 3853203A-2007 Printed in U. S. A. © Copyright 2007 R. L. Drake LLC 2 Caution Statements WARNING: TO PREVENT FIRE OR ELECTRICAL SHOCK DO NOT EXPOSE TO RAIN OR MOISTURE A product and cart combination should be moved with care. Quick stops, excessive force and uneven surfaces may cause the product and cart combination to overturn. [. . . ] One at the bottom of the microphone and one near the top. It is important to keep one of these areas uncovered when the microphone is in use so that the IR signals will reach the sensor. BATTERY CHARGING CONNECTOR - This connector is located on the bottom of the unit. The BC60 Battery Charger plugs into this connector to charge the installed Nickel Metal Hydride (Ni-MH) batteries. Do not attempt to use this charger if Nickel Cadmium (Ni-Cd) batteries are installed as the charging rate is too high for them. UNDER NO CIRCUMSTANCES SHOULD THE CHARGER BE USED IF ALKALINE OR CARBON ZINC BATTERIES ARE INSTALLED !BATTERY COMPARTMENT SLEEVE - This sleeve protects the batteries and microphone adjustments. To remove it, unscrew it by rotating it counterclockwise. POWER LED - This LED lights green when charged batteries are installed and the power switch is turned on. The color changes to red when batteries are low. POWER SWITCH - This switch turns the microphone on and off. LO HI POWER SWITCH - This switch is used to adjust the power applied to the IR transmitters. Setting the switch on LO (down) will consume less battery power but will give somewhat less IR range. Setting the switch on HI (up) will extend the IR range, but will cause the batteries to discharge sooner. CHANNEL SWITCH - The channel switch selects between CH 1 and CH 2. If CH 1 is selected, the CHANNEL A LED on the SRR60 Receiver will light and the CHANNEL A Volume and Equalizer controls will be used. If CH 2 is selected, the SRR60 CHANNEL B controls will be active. The units are shipped with the switch in the CH2 (B) position. If two microphones are used it is important that one of them be on CH 1 and the other on CH 2 so that they don't interfere with each other. BATTERY COMPARTMENT - The battery compartment is designed to hold two "AA" sized batteries. Nickel Metal Hydride (Ni-MH) batteries should be used so that they can be recharged without taking them out of the unit. Nickel Cadmium (Ni-Cd) batteries can be used if they are removed for recharging using an external charging system. Carbon zinc or alkaline batteries can be used in a pinch, but NO ATTEMPT SHOULD BE MADE TO RECHARGE THEM ! [. . . ] DRAKE is not responsible for damage caused by lightning, nonprofessional alterations, "acts of God" shipping damage, poor storage/handling, etc. DRAKE will make note of any shipping damage upon receipt. You will need to send proof of purchase to receive warranty service. Typically, a copy of the invoice from an R. L. [. . . ]