User manual DRAYTEK VIGOR 2130 V1.2

[. . . ] Vigor2130 Series High Speed Gigabit Router User's Guide Version: 1. 2 Firmware Version: V1. 3. 0. 1 Date: 29/04/2010 ii Vigor2130 Series User's Guide Copyright Information Copyright Declarations Copyright 2010 All rights reserved. This publication contains information that is protected by copyright. No part may be reproduced, transmitted, transcribed, stored in a retrieval system, or translated into any language without written permission from the copyright holders. The following trademarks are used in this document: Microsoft is a registered trademark of Microsoft Corp. [. . . ] By connecting 3G USB Modem to the USB port of Vigor router, it can support HSDPA/UMTS/EDGE/GPRS/GSM and the future 3G standard (HSUPA, etc). Vigor router with 3G USB Modem allows you to receive 3G signals at any place such as your car or certain location holding outdoor activity and share the bandwidth for using by more people. Users can use four LAN ports on the router to access Internet. Also, they can access Internet via SuperG wireless function of Vigor router, and enjoy the powerful firewall, bandwidth management, VPN, VoIP features of Vigor router. After connecting into the router, 3G USB Modem will be regarded as the second WAN port. However, the original Ethernet WAN still can be used and Load-Balance can be done in the router. Besides, 3G USB Modem also can be used as backup device. Therefore, when WAN is not available, the router will use 3. 5G for supporting automatically. The supported 3G USB Modem will be listed on DrayTek web site. Please visit www. draytek. com for more detailed information. Below shows the menu items for WAN. 110 Vigor2130 Series User's Guide 4. 1. 1 Internet Access This page allows you to set WAN configuration with different modes. Use the Connection Type drop down list to choose one of the WAN modes. The corresponding page will be displayed. Static For static IP mode, you usually receive a fixed public IP address or a public subnet, namely multiple public IP addresses from your DSL or Cable ISP service providers. In most cases, a Cable service provider will offer a fixed public IP, while a DSL service provider will offer a public subnet. If you have a public subnet, you could assign an IP address or many IP address to the WAN interface. To use Static as the accessing protocol of the internet, please choose Static mode from Connection Type drop down menu. The following web page will be shown. Vigor2130 Series User's Guide 111 IP Address Subnet Mask Gateway IP Address Primary DNS Server Type the IP address. You must specify a DNS server IP address here because your ISP should provide you with usually more than one DNS Server. If your ISP does not provide it, the router will automatically apply default DNS Server IP address: 198. 95. 1. 1 to this field. You can specify secondary DNS server IP address here because your ISP often provides you more than one DNS Server. If your ISP does not provide it, the router will automatically apply default secondary DNS Server IP address: 4. 2. 2. 1 to this field. Such function allows you to verify whether network connection is alive or not through ARP Detect or Ping Detect. Choose ARP Detect or Ping Detect for the system to execute for WAN detection. [. . . ] Change your PC IP address to 192. 168. 1. 10. Open Firmware Upgrade Utility and key in Router IP 192. 168. 1. 1 manually. Install Router Tools on one computer that connects to Vigor Router's LAN port. Make sure the computer can ping Vigor's LAN IP. [. . . ]