User manual DREAM MULTIMEDIA DREAMBOX 7020S

[. . . ] â· Never open the unit yourself!Should it become necessary to open the unit, this must be carried out by qualified personnel. Conversion or modification of the unit leads to loss of warranty if not carried out by a specialist dealer and certified in writing. An incorrect installation of the hard disk results in you losing all of your rights under the guarantee. [. . . ] This output also provides the Dolby Digital-Signal (AC3) when this is broadcast. 2 RS 232 serial interface The RS 232 interface is used to update the operating software and for preprogramming with a PC. 3 Ethernet The Ethernet interface can be used to update the operating software and for pre-programming with a PC. Take care that dead batteries from the remote control and electronic scrap are not disposed of in ordinary rubbish, but are properly disposed of (return to the specialist dealer, or special waste disposal). All available options are displayed over 4 coloured dots (red, green, yellow, blue) and can be activated with the remote control. The options change depending on the menu, and are labelled appropriately in each menu. You can leave all menus and channel lists with the LAME!2 Set-up-menu Leave the menu with "close" or with "LAME!2 Network This shows the set-up for your network. IP: Enter the IP address of your Box here (e. After entering your set-up, save your settings with "save", or , , abort". After entering your set-up, save your settings with "save", or , , abort". 5 Remote control This allows you to configure your remote control. After entering your set-up, save your settings with "save", or , , abort". You can adjust the repeat rate and the delay rate. After entering your set-up, save your settings with "save", or , , abort". 6 Video This allows you to configure your video set-up. 8 Language This allows you to choose the language for the OSD. After entering your set-up, save your settings with "save", or , , abort". 7 Skin This allows you to choose between different OSD skins. After entering your set-up, save your settings with "save", or , , abort". A new language becomes active the next time you reboot. [. . . ] Set up "TV control mode" A four-digit TV device code is selected from the TV model list in the table in Chapter 13 (pages 23 - 32) and entered. TV mode -> <<Set-up>> -> number -> number -> number -> number Enter the TV code with the numeric keypad on the remote control. Each number input is acknowledged by the TV key blinking once. After the fourth digit has been input, a valid code is acknowledged by the TV key blinking twice. [. . . ]